Installing the Batteries
Your iPAQ Personal Mini-CD Player PM-1 is equipped with
rechargeable batteries. You have the option of listening to your
favorite music on battery power or plugging the PM-1 into a
standard electrical outlet.
Note: Before using the PM-1 for the first time, the
Ni-MH batteries should be charged for 8 hours.
Follow these steps to install the batteries:
1. Slide the release lever on the front of the
PM-1 to the open position to open the
PM-1 cover.
2. Push back the tab on the side of the
battery compartment cover and lift up to
remove it.
3. Place the rechargeable batteries that
came with your PM-1 into the battery
compartment according to the diagram
inside the compartment.
WARNING: Do not mix rechargeable
batteries with non-rechargeable batteries.
Charging the Batteries
The battery icon on the display screen
shows the amount of charge held by the
batteries (when the PM-1 is not plugged into an AC electrical
outlet). The battery icon is divided into three segments that
show the approximate power capacity of the batteries. Replace
or recharge the batteries when the battery icon goes blank.
To charge (or recharge) the batteries that came with your PM-1,
plug the PM-1 into a standard electrical outlet while the
batteries are in the battery compartment. Do not charge the
batteries for more than 8 hours to avoid reducing battery life.
Using the Power Supply Adapter
Before using the power supply adapter, make sure your local
voltage corresponds to the adapter’s voltage. Only use the
supplied adapter because other types of adapters may damage
the player. To connect the power supply adapter, plug the large
two-pronged end into a standard electrical outlet and plug the
single-pronged end into the DC 3V socket on the player.
Note: Always disconnect the power supply adapter when you are not using
it unless you are recharging the batteries.
Features o Your PM-1 Player
Your PM-1 player has the following features on its left side,
front, and right side.
Features o Your Inline Remote Control
The function keys on the inline remote control are similar to
those on the PM-1 player. The inline remote control is
equipped with an LCD display so that you can conveniently
check the playback status.
Plug your inline remote control into the headphone jack on
the PM-1. Your headphones then plug into the headphone jack
on the inline remote control.
No. Control Function
1Mode Program, Repeat, Equalizer, File/Album searching
2Next Skip forward to next track/directory
3Prev Skip backward to previous track/directory
4Volume + Increase the volume level
5Volume – Decrease the volume level
6Stop Stop playback / power off (hold for 3 seconds)
7Play/Pause Start playback / power on / pause playback
8Hold Lock all controls on the player
9Open Open or lock the door of the player
:Headphone Headphone jack on the player
;Line Out Line out jack to connect with other amplifiers
<DC 3V DC 3V to connect with power supply adapter
No. Control Function
1Cord Cord to connect the remote and the unit
2Clip Secures the inline remote while jogging
3Hold Lock all controls on the inline remote control
4Headphone Headphone jack on the inline remote control
5Stop Stop playback / power off (hold for 3 seconds)
6Previous Skip backward to previous track/directory
7Play/Pause Start playback / power on / pause playback
8Next Skip forward to next track/directory
9Volume + Increase the volume level
:Volume – Decrease the volume level
;Mode Program, Repeat, Equalizer, File/Album searching
<LCD Liquid Crystal Display screen
Villain Getting Started.fm Page 2 Tuesday, September 4, 2001 10:33 AM
