Component Playgrounds ST20 User manual

Installation
Instructions ST20
Required Crew: 2 Required
Concrete: 8-10, 80 lb. bags
Required Tools:
● Wheelbarrow
● Step Ladder (6’ or taller)
● Shovel
● Tape Measure
● Digging Bar or Pick
● Level
● Allen Wrench (Provided)
● Open end or Box Wrenches: 9/16”, ¾”
● Hammer or Mallet
● Ratchet Handle & Sockets: 9/16”, ¾”
● Marker Pen
● Drill: Cordless or electric, or impact driver
Component Playgrounds is concerned about the safety of your vision. It
is important that you choose to protect your vision by wearing proper
safety glasses during each and every phase of this construction
process.
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE BEGINNING
The ST20 can be installed as a one day project. The normal time required
to install the ST20 is about 2-3 hours for a two man crew. This time
requirement will vary dependent upon the composition of the soil and the
speed of the installers. Mix and pour the concrete as the last step. *Before
digging, please obey local laws by notifying your local underground
utilities marking organization*

MT Fire Pole or
Turning Bar Add-On
Step 1: Determine desired location of fire pole on the top rail, or the turning
bar on the upright ladder leg.
Step 2: Determine the location of hole and dig hole as shown below.
Step 3: Clamp fire pole or turning bar into position, level and cement in
ground.

Installation Instructions
1. First find the area you would like to place the set. Make sure you have enough room. Dig
the ladder hole centered at 6.5’ from each end side to side, and 10’ centered front to
back (As shown below). Then lay the ladder on the ground with the legs at the center of
the hole. Slide the top rail through the top sleeve of the ladder to the 43.5” mark. Use
two ⅜” x ⅜” set screws to secure the top rail to the ladder.

2. Lift the ladder into the hole. Have one person hold the ladder to help get it in a level
position before marking the next two holes.
3. While one person holds the ladder, have the other check the level of the structure as
shown below.

4. Once the set is held level, you can mark your holes for the turning bar and fire pole. This
is best done by placing the items where you intend them to be and marking the holes
around them (as shown below). Once the holes are dug to the right specs, assemble the
turning bar and the fire pole by following the directions on the fire pole and turning bar
instruction sheet.

5. Now that the structure is all assembled take time to make any adjustments necessary to
level out the structure.

Component Playgrounds
BRASS BUSHING SWING HANGER
1. Loosen and remove the two nyloc jam nuts.
2. Reassemble on to swing top rail. Tighten securely so that the hanger is
firmly attached in place and cannot slide or swivel along top rail.
3. Attach carabineer with chain through the ring.
Note: We recommend you check the pendulum in the swing hangers at
least every 6 months for normal wear.

When you are satisfied that the structure is level, mix and pour the
concrete according to the package directions. You will use
approximately one and a half to two 80 lb. bags in each leg hole.
Concrete will cure faster in warm conditions and slower in cold
conditions. The package directions on the concrete you buy will indicate
approximate curing times. If you are in doubt, it is better to wait longer
allowing the concrete more time to cure. We recommend 3-5 days
before use.
The amount of concrete to be used in each hole may vary. For
example: If you are installing your play structure into a grassy area, you
may want to leave the concrete about three to four inches below the top
of the hole. This will allow you to replace the sod and have enough soil
depth for the grass to continue growing. As a result of this, you will use
a lesser amount of concrete than someone who chooses to fill the
concrete to the top of the hole. The concrete should only be filled to the
top of the hole if you are planning to install 6 – 12 inches of soft fall
ground cover. The concrete footings should never be exposed as this
presents a potential risk of injury to those who use this play equipment.
Double Check and Secure: Before using your swing set, double
check and secure any loose set screws or nuts and bolts and enjoy
your Component Playground. Allow all of the concrete to cure
completely before using your playground. (3-5 days).
After concrete has cured, assemble and attach swing chains
and seats.

Read Before Use
Congratulations! You have just purchased one of the finest pieces of playground equipment available. Your family will
enjoy many hours of fun with this fine equipment. Playground equipment can be most enjoyable, but there are some
dangers if not used properly. You should be aware of the following:
Equipment should be installed in a level area, free from obstructions, with enough space to allow for adequate
clearance in all directions when equipment is in maximum use.
Keep objects away from equipment that could interfere with persons using it or that could be hazardous.
Misuse or abuse of this playground equipment is dangerous and can cause serious injury.
This equipment should be inspected before each use and any worn, defective or missing parts should be replaced.
Children should play on equipment only with adult supervision and should be duly warned of the potential hazards in
this type of equipment when used improperly. Children should be instructed as to proper caution to take in its use.
Equipment should NOT be used when it is wet or icy.
Equipment should only be used in a well-lit area.
Do NOT use equipment when tired, under stress or emotionally upset.
Do NOT overcrowd.
Do NOT use equipment when under the influence of alcohol or drugs.
Do NOT attempt somersaults or gymnastic stunts on or using this equipment.
Know your own limitations and exercise caution at all times.
Do not jump off of equipment when dismounting. It is a dangerous practice to jump on or off equipment.
Do not attempt to use equipment for something other than the use for which it was designed and intended, or in a
manner other than that for which it was designed and intended.
While every attempt is made by Component Playgrounds to ensure the highest degree of
safety in all of our equipment, we cannot guarantee freedom from injury. The user
assumes all risk of injury due to use. All merchandise is sold on this condition, which no
representative of the company can waive or change.