Fasten both standoffs to the back of the
DIN-rail's designated holes using the
screw-nuts.
The DIN-rail bracket can be installed to
the mounting bracket at
both horizontal and vertical orientations.
Use 2x flat head Phillips screws and
fasten through the designated holes
(marked in RED) to the DIN-rail
bracket's standoffs.
Fasten the mounting bracket to the
fitlet2 using 2x flat head Phillips screws
Page 2
Pay attention to the mounting bracket's
holes, the flat head screws should fit
perfectly into the countersunk holes; if
not, simply flip the bracket.
If the DIN-rail bracket is not used, ignore
Step-2 and install the mounting bracket
to theYELLOWmarked countersunk
holes.
Align the mounting bracket's holes with
the fitlet2 bottom cover's mounting holes