CONFORTotal 7K User manual

SPLIT TYPE WALL MOUNTED AIR CONDITIONER
USER’S MANUAL
Read the manual carefully before operation and keep it for reference.
This manual is only for reference, please comply with actual appliance
you selected. manufacturer hold the authority to redesign or modify its
products without notice.

SAFETY PRECAUTIONS
WARNING: Following these basic precautions will reduce the
risk of fire, electrical shock, injury or death when using your
air conditioner.
1. Air conditioner must be connected to proper electrical outlet or breaker with the correct
electrical supply. And only the specified power can be used.
2. Proper grounding must be ensured to reduce the risk of shock and fire
DO NOT CUT OR REMOVE THE GROUNDING PRONG. If you do not have a
three-prong electric receptacle outlet or breaker in the wall, have a certified electrician
install the proper receptacle or breaker. The wall receptacle or breaker MUST be properly
grounded.
3. DO NOT use if power cord is frayed or otherwise damaged. Also avoid using it if there
are cracks or abrasion damage along the length, plug or connector.
4. DO NOT USE ANADAPTER ORAN EXTENSION CORD.
5. DO NOT block airflow inside or outside the air conditioner with blinds, drapes, protective
covers, shrubs or blusher.
6. Be careful of sharp edges on the front and rear fins of the unit that could cut and cause
serious injury.
7. Be careful when lifting the air conditioner to install or remove the unit. Always use two or
more people for this.
8. Always cut off the power of air conditioner before servicing it or moving it.
9.In some type of units, there is no appropriate plug corresponding to its power cord
because of power, Under this condition, an appropriate power breaker should be
linked to its power cord, therefore, the instruction part associated with plug using is not
available for these types.
10. An all-pole disconnection switch having a contact separation of at least 3mm in all
poles should be connected in fixed wiring.
11. The appliance shall be installed in accordance with national wiring regulations.
12. This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised to ensure that they
do not play with the appliance.

USER’S MANUAL
-1-
CONTENTS
1. SAFETY INSTRUCTIONS
Symbol Description…………………………………………………..……….………..….2
Installation Instruction…………………………………………………..…….……….…. 2
Operating Instruction………………………………………………………….……….…..3
Safety Instruction… …………………………………………………………..……….… 6
2. PRODUCT INTRODUCTION
Protect Functions………………………………………………….. …….….………….…7
3. DESCRIPTION OF COMPONENTS
View of Unit………………………………………………………………………...…………8
Display screen………………………………………………………………….……..……...9
Indicator light………………………………………………………………….……..……. 9
Remote Controller…………….……………………………..……………….….………..10
Remote Controller Display…………………………………………………….………….11
4. OPERATING METHOD
AUTO, HEAT, COOL,sweep and DRY operation………………………………………….12
Clock Setting and On Timer…………………………………………………………………13
Off Timer and Program Control…………………………………..………………….…...…14
Emergency Run…….…………..…………………………………………………..…...….15
How to Adjust Air Flow……………………………………………………………………….15
Sleep Operation………………………………………………..……………………………15
5. SERVICE AND MAINTENANCE
Clean the front panel and remote controller………………………….……………….16
Clean Air Filter…………………..……………………………………………….…….……16
No use for long time…………………..…………………………………….…………....17
Recommendations for Energy Saving…………..……...……………………………..…18
6. TROUBLESHOOTING
Air Conditioner is in Error…………………………………………………………….…….19
Remote Controller is in Error…………………………………..…………………….….…20
7. NORMAL PHENOMENONS……………………………………….…………………..21

USER’S MANUAL
-2-
SAFETY INSTRUCTIONS
〖Symbol Description〗
Asymbol indicating operation which may cause personnel
casualties or serious damages.
Warning:
Caution: Asymbol indicating operation which may cause personnel
casualties or property damages.
〖Installation Instruction〗
Improper connection may decrease the
efficiency or cause air conditioner stop
running. Water or refrigerant leakage may
be resulted as well.
Proper connection o
f
wires and piping
Make sure that the capacity of socket o
r
breaker and power cable is sufficient, the
voltage is correct and the socket o
r
breaker is grounded. There may be hazard
of fire or electric shock otherwise.
Power specifications
Installation environments
Do not install air conditioner at the place
where there is flammable or corrosive air.
Please confirm the following before installation
Operating instruction
Please operate air conditioner in
accordance to this manual.
Caution

Never install by yourself.
Split type air conditioner will work for you for a long period of time if it is correctly installed.
Improper installation could cause problems such as leakage of water or refrigerant, electric
shock or fire.
Warning

USER’S MANUAL
-3-
〖Operating Instruction〗
Electrical safety
Grounding: This room air conditioner must be grounded.
Grounding reduces the risk of electric shock by providing an escape wire for the
electric current.
If the power cord has a grounding plug with a grounding wire, plug it into an outlet that
is properly installed and grounded.
If the power cord has not a grounding plug with a grounding wire ,the grounding wire
must connect the breaker that is properly installed and grounded.
Warning: Improper use of the grounding plug or breaker can result in a risk of electric shock. Call
a qualified electrician if you don’t understand the grounding instructions or if you are
not sure if the air conditioner is properly grounded. If the wall outlet or breaker is not
grounded, please contact an electrician to have it replaced with a properly grounded
outlet or breaker.
Do not, under any circumstances, cut or remove the third (ground) prong from
the power cord.
Adapter plug: We strongly advise against using an adapter plug or breaker.
Operating conditions
1. Temperature:T1 instance: -7℃~43℃(16℃~43℃in cooling-only type)
T3instance:-7℃~52℃(16℃~52℃in cooling-only type)
If the unit runs beyond the temperature for a long time, it may cause cooling capacity to decrease
or protector to work.
2. Relative humidity: <80%
If the unit runs beyond the humidity range, condensate may be formed near blade and outlet of
air conditioner. It’ s normal.
3. In heating operation, strange smell may come from the unit. It is Normal phenomenon.
4. The performance parameters refer to name plate.
5. The waterproof level of indoor unit is IPX0. Do not use it in the laundry or bathroom.
6. The outdoor unit can’ t be installed in a closed area.
WARNINGS
Following the safety messages is very important. These messages can save
you from being injured or killed. Warning symbols alert you to be careful and
means danger. Always follow instructions to be safe and reduce chances of
injury or death. Warning and danger signs will precede safety messages.

USER’S MANUAL
-4-
7. The fuse for indoor unit main board: T3.15AL 250V～(9K-22K)；
The fuse for indoor unit main board: T 5AL 250V～(18K-24K)；
The fuse for outdoor unit main board: T15AL 250V～or T20AL 250V～(9K-12K)；
The fuse for outdoor unit main board: T30AL 250V～(18K-24K)；
Tips
Install the unit on the north side, as normally that is the shaded side. This will
enhance the operation of your unit.
Use correct electric voltage and proper ampere for the unit to run effectively.
Only let a certified electrician do any modifications to your electrical outlet or
breaker.
Use a dedicated line for the operation of your air conditioner to avoid the possibility
of an electrical surge.
If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person in order to avoid a hazard.
The dimensions of the space necessary for correct installation of the appliance
including the minimum permissible distances to adjacent structures.
The appliance shall be installed in accordance with national wiring regulations.
Disconnect the power supply before cleaning and maintenance.
If the appliance is not connected by plug，an all-pole disconnection device which
has at least 3mm separation distance in all pole and a residual current
device(RCD)with the rating of above 10mA shall be incorporated in the fixed wiring
according to the national rule.
If the appliance is connected by plug，it must be positioned so that the plug is
accessible.
Energy Saving Guide
When installing your air conditioner make sure to seal all areas where there is a
possibility of air leakage.
Airflow should not be blocked inside either by curtains, drapes or furniture or
outside by shrubs or bushes.
Do not needlessly use an electrical light or other appliances that produce heat.
Keep the blinds and the drapes drawn on all the other window.
While cooking use an exhaust fan in the kitchen to remove the excess heat
produced.

USER’S MANUAL
-5-
〖Operating Instruction〗
Only single-phase a.c. power can be used.
please refer to nameplate for details.
Use the specified power cord; do not
change it.
Do not put fingers or sticks into the inlet or
outlet of air conditioner; the running fan may
cause injuries.
Do not put anything on the outdoor unit.
Do not switch on or off the unit by plugging or
pulling off the plug, or by switching on or off
the breaker .
Keep indoor ventilated, especially when
there is operating gas equipment.
Do not substitute fuse with lead wire or other
materials.
Pull off power plug or switch off breaker if
the air conditioner is not used for a long
time.

USER’S MANUAL
-6-
〖Safety Instruction〗
Don not connect the earth line to gas pipe,
water pipe. Improper grounding may cause
electric shock.
Do not pull off the power plug or switch off
the breaker when it is in operation.
Switch off the unit; cut off the power source
and contact service agent if there is abnormal
phenomenon (e.g. burning smell comes out).
Do not install air conditioner at the place
where flammable gas may leak.
Do not place plants or animals directly in the
path of the air conditioner’ s airflow. Doing so
could harm them.
Please contact service agents for service.
Improper service may cause accident.
Switch off the unit, cut off the power source
and make sure the fan stops before cleaning
the unit.
For removal and installation of air
conditioner, please refer to professionals
or contact service agents.
Warning:
The appliance is not intend for use by young children or infirm
persons without supervision.
Young children should be supervised to ensure that they do not play
with the appliance.
If the supply cord is damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualified person in order to avoid a
hazard.

USER’S MANUAL
-7-
PRODUCT INTRODUCTION
〖Protect Functions〗
Protect functions can prolong the air conditioner’ s service life and provide more comfortable airflow.
Delay-starting protection for the compressor
The compressor will restart working at least 3 minutes after being turned off to keep the pressure balance
of the cooling system.
Remarks:
Defrosting (not available for cooling-only type air conditioner)
The outdoor heat exchanger may frost if the outdoor temperature is low and humidity is high. In this case,
auto-defrosting has operated for sometimes. pause indicator will be on, indoor and outdoor fan stop.
Heating overload protection (not available for cooling-only type air conditioner)
When the temperature of indoor pipe is too high, air conditioner enters heating overload protection.
Blowing residual heat function (not available for cooling-only type air conditioner)
Indoor fan will keep running at low fan speed for some seconds when air conditioner is stopped in heating
mode.
Cooling airflow proof (not available for cooling-only type air conditioner)
In the first several minutes of heating operation, PAUSE indicator lights; indoor fan doesn’t run and louver
blades can not be controlled. About some minutes later, air conditioner will blow heat airflow, PAUSE
indicator is off.
Freeze-prevention
To prevent indoor heat exchanger freezing in cooling and dehumidification operation, compressor or
outdoor fan may stop running; indoor fan speed will be adjusted to a higher gear automatically.
Dry for enzyme-prevention (optional)
Indoor fan motor will go on running for 3 minutes at low fan speed when turned off in cooling mode in order to
keep dry condition inside the unit.
Reset power or Auto restart( alternative)
Reset power: When there is a power suspension, air conditioner will automatically switch off. When the
power is back, the unit will automatically reset power. For energy saving if there is no person in the room,
air conditioner will stay in PAUSE status. User needs to turn on Air conditioner by remote controller.
Auto restart: The unit memories the operation mode, air flow setting, temperature setting etc., so that
should there be a power failure when the unit is in operation, it will automatically return the same
operating conditions when the power is restored.
Cooling overload working (optional)
Drip proof (optional)
In cooling and dehumidification operation, louver blades can change the position automatically to prevent
from dripping.

USER’S MANUAL
-8-
DESCRIPTION OF COMPONENTS
〖View of Unit〗
Indoor unit
Outdoor unit
Air inlet
Drain
p
i
p
e
Power cord
Air outlet
Remarks:
The air conditioner is consisting of indoor unit, outdoor
unit and remote controller. The design and shape are
different for different models. The above figures are only
schematic, and they may be slightly different from the
actual appliances you selected.
Air outlet
Air inlet(back)
Pi
p
e and wires