Core LWW User manual
1. This product is intended to be installed by an experienced electrician.
2. Make sure to TURN OFF MAIN POWER prior to installation of any electrical device.
3. This product is designed for OUTDOOR use
INSTALLATION GUIDE
For wet rated and outdoor LED strips (Surface Installation)
ARCHITECTURAL
1
Mount one extension arm onto wall. Make
sure to check that the proper distance is
allocated then mount the other extension
arm. Fasten them securely, making sure the
extension arms are not wiggling or loose.
LWWEXTENSIONARMINSTALLGUIDE | P1
150 West Carob St., Compton, CA 90220
T: 888.737.9192 | F: 888.789.4643
2
Adjust extension arm length by loosening the
hex screws and extending the inner channel to
the desired length. Tighten back the hex
screws to set the length.
3
Tilt the fixture to one side and fasten the M4
screws through the screw holes on one side
of the adjustable brackets. Tilt the fixture in
the opposite direction and fasten the M4
screws on the other side.
1. This product is intended to be installed by an experienced electrician.
2. Make sure to TURN OFF MAIN POWER prior to installation of any electrical device.
3. This product is designed for OUTDOOR use
INSTALLATION GUIDE
For wet rated and outdoor LED strips (Surface Installation)
ARCHITECTURAL
4
In case the mounting extension arm is
misaligned, the adjustable bracket can be
moved to another position by loosening the
set screws.
LWWEXTENSIONARMINSTALLGUIDE | P1
150 West Carob St., Compton, CA 90220
T: 888.737.9192 | F: 888.789.4643
5
Connect the loop in loop out cables and finish
the wiring to complete the installation.
Table of contents
