Cree LEDway XSP Series User manual

LEDway® and XSP Series
Direct Arm Pole Adapter Bracket
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D’INSTALLATION
1 of 2 LPN00222X0001A0
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be
followed including the following:
READ AND FOLLOW ALL SAFETY
INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l’alimentation avant l’installation.
SAVE THESE INSTRUCTIONS FOR
FUTURE REFERENCE
TO INSTALL:
NOTE: Use dimensions on template shown on
the back page for drilling if pole is not pre-
drilled. (Template is not to scale.)
STEP 1:
Remove any extra gaskets plugs from the foam
gasket and place gasket over (2) bolts extending
from the Mounting Plate. See Figure 1.
STEP 2:
Insert Backing Plate behind mounting surface.
See Figure 1.
STEP 3:
Secure Mounting Plate and gasket to mounting
surface by tightening (2) bolts from Step 1 into
the Backing Plate. Torque bolts to 120 in. lbs.
See Figure 1.
STEP 4:
Attach the Transition Direct Arm Adapter to the
Mounting Plate by using (2) supplied bolts and
washers. Torque bolts to 120 in. lbs. See Figure
1.
STEP 5:
Attach the Transition Direct Arm assembly
to luminaire by referencing the luminaire
installation sheet.
1
Backing Plate
Foam Gasket
Mounting Plate Transition Direct
Arm Adapter

2 of 2 LPN00222X0001A0
www.cree.com/canada
© 2016 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change.
See www.cree.com/canada for warranty and specifications. Cree®and LEDway®are registered trademarks, and the Cree logo is
a trademark of Cree, Inc.
2.000"
(51 mm)
2.000"
(51 mm)
1"
(25 mm)
0.344"
(9 mm)
Hole
2 Required
0.500"
(13 mm)
Hole
POLE TEMPLATE