Crestron BB-1600 Back Box
Installation Guide - DOC. 5835A Back Box: BB-1600 •• 5
Detail of Supplied Template" on page 10 for an illustrative
reference.
9. Position one metal mounting plate along the top horizontal edge
so that it covers the two center holes marked “A”.
10. Use two pan head screws (1” length) supplied, to loosely secure
the bracket and plate to the mounting surface.
11. Position one metal mounting plate along the bottom horizontal
edge so that it covers the two center holes marked “A”.
12. Use two pan head screws (1” length) supplied, to loosely secure
the bracket and plate to the mounting surface.
13. Tighten four screws installed in steps 10 and 12 with a Phillips
screwdriver. Be careful not to crack gypsum board.
14. Verify that the rim of the back box is recessed approximately
1/8" from the mounting surface and use fingers to tighten four
socket hex head screws. Using a socket screwdriver, tighten each
screw an additional 1/8-turn.
15. If touchpanel is available, secure touchpanel to BB-1600 using
four pan head screws, supplied with the touchpanel.
Post-Construction Method
The only tools required are a gypsum board saw (or equivalent), a socket
screwdriver (length should not exceed 4.5"), a #2 Phillips tip screwdriver,
a drill, a 5/16” drill bit, and a #20 drill bit. Complete the following
installation procedure in the order provided.
1. Locate an area on the wall or other suitable mounting surface that
is clear of studs, wires, and other obstructions.
2. Make a small hole near the middle of the designated site; verify
location is suitable.
3. Fasten cutout template (40047, supplied) to mounting surface;
verify that the template is level.
4. Cut out and remove the traced shape of mounting surface.
5. Drill four 5/16” through holes. Refer to "Cutout Detail of
Supplied Template" on page 10 for an illustrative reference.
