D-Bodhi SHELFMATE Installation guide

shelf
1 pc
frame
1 pc
shelf adjuster
1 pc*
hex screws
2 pcs
screws
2 pcs
L E T ’ S G E T S TA RT E D !
A S S E M B L I N G I N S T R U C T I O N S
( check if all parts are in the box )
TOOLS YOU NEED TO PREPARE
35x25.5x35 cm
B
50x25.5x35 cm
20x25.5x35 cm
E
25x25.5x75 cm
D
A
65x25.5x35 cm
allen key screwdriverdrill marker / pencil
(included)
wall plugs
printed on recycled paper, of course
C
*note : SHELF A and C has 2 adjusters
B, D and E have only 1
M E E T T H E OT H E R

Place the adjuster(s)
STEP 2
STEP 3 STEP 4
A S S E M B L I N G & H A N G I N G
Screw the shelf in its frame as pictured
above, then tighten the screws (A)
STEP 1
A
M A K E I T E A S Y, U S E T H E TO O L K I T
2. Pierce the drill marks, position the box
and transfer the marks to the wall
3. Drill holes at the marked spots
S PAC I N G
A
4. Screw the screw into the wall
(use plugs if necessary)
Pierce the centre of the cross marks to drill your holes in the right place.
for
cho osing
Use the tee to align the SHELFMATES
to each other horizontally and vertically.
1. Cut out the measurement Tee (A)
and use the inside of the box as
a drill hole template (B)
B
A
Use the Tee to position the SHELF modules
towards each other horizontally and vertically
Congratulations!
Your SHELF is ready
Attach screws to the wall. Hang the SHELF and
fine tune with adjuster(s) (A)
note: SHELF B, D and E have only 1 adjuster
T H A N K S
H A N G I N G M U LT I P L E
More hanging tips on our website.