DELTA GROUP VIVOTEK AM-71G User manual

Revison History:
Rev. 1.0: Initial release
VIVOTEK Mounting Accessories
AM-71G Junction Box
Installation Guide
Mounting Dimensions
51.00 51.00
51.0051.00
Installation
II
Compatible VIVOTEK Cameras
I
Compatible cameras/brackets
FFD9167-HT-v2, FD9367-EHTV-v2, FD9365-EHTV-v2, FD9391-EHTV-v2, IB9367-EHT-v2, IB9367-EHT-v2 (5-50MM), IB9365-
EHTV-v2, IB9391-EHTV-v2
A 3/4" conduit is required for routing the cables with waterproof
connection.
Attach the included alignment sticker to a preferred position. Drill
holes on the wall and install the junction box. If space behind the
wall allows, you may also pass cables through the wall.
Remove the top cover and unhook the tether wire.
NOTE: If you have a POE extender or EPoC device, install them now.
Refer to the later section for details.
Install the cable gland and pass cables through it.
Remove the dome cover and waterproof connectors.
Pass cables through the center hole on the top cover. Secure the
top cover by driving screws.
5 ~ 8mm
Pass cables through the routing holes and install the camera to box by
driving screws.
Connect cables to the Ethernet port and terminal block.
Note that the silicon waterproof seals should also
be properly installed on the camera. Insert the cables
through the waterproof seals.
1
2
34
567
9Secure the camera top cover.
Open a live view console and adjust the shooting direction. Refer to the
camera's QIG for more information.
Part no.: 5019034100
Accessory Ordering part no.: VIO100000003
x4 x4 x4
Package Contents
Compatible accessory models: AM-312, AM-412, AM-522
Connect a ground wire to this position.
8
13kgf.cm
Remove the plastic cover and seal ring from the conduit hole you
want to use, and install them the conduit hole you don't want to use
to make sure the bracket is waterproof.
10

Connect a ground wire to a surge protection device using the
grounding hole on the EPoC Tx module so that the device is
protected.
≧20AWG
Surge protection
Equipment enclosure
Equipment grounding
AT-PSP-001
Surge Protection