2 3
STEP 2
Attach the square plate (1) to the square
plate connectors (3) with M6x10 bolts
(5) and eight M6 washers (10) using
Allen wrench from tool kit (4).
PACKAGE CONTENTS
TOOLS NEEDED
70lbs
(31.75kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
WARNING!
Phillips
Screwdriver
1 (x1)
Square Plate
2 (x1)
TV Arm Set
9 (x4)
M4 Washer
10 x12)
M6 Washer
11 (x4)
M8
Washer
12 (x6)
M4 Spacer
M6/8 (20mm)
Spacer
4 (x1)
Tool Kit
5 (x8)
M6x10
6 (x4)
M4x12
M4x30
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual. Do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
NOTE: NOT ALL HARDWARE INCLUDED WILL BE USED
13 (x8)
M6/8 (5mm)
Spacer
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3
YEARS. ADULT SUPERVISION IS REQUIRED.
8 (x4)
M8x20
M8x35
M8x45
ASSEMBLY STEPS
STEP 1
Slide the square plate connectors and
rubber pads (3) over the top of the poles
on your VIVO STAND-TV03E TV cart.
Tighten the grub screws using Allen
wrench from tool kit (4).
3(x2)
Square Plate
Connector and
Rubber Pad
7 (x4)
M6x20
M6x35
STEP 3
Clip bubble level from tool kit (4) onto
the square plate (1). Adjust the level of
the square plate by loosening the grub
screw on the back of the square plate
connector (3). Retighten grub screw
when square plate is level.
STEP 4
Secure TV arm set (2) to the back of
your TV using bolts (6, 7, 8) and washers
(9, 10, 11), depending on the size and
depth of the mounting holes in the TV.
For curved or recessed back TVs, spacers
(12, 13) may be required.
STEP 5
Attach the TV arm set (2) with TV to
the square plate (1). Tighten the safety
bolts on the bottom of the TV arm set to
secure the TV to the stand. If additional
leveling and height adjustment is
required aer TV is attached, repeat
Step 3.
STEP 6
If used to upgrade a VIVO STAND-
TV03E TV cart to hold dual screens, we
recommend positioning both TVs to
face forward with one mounted over
the other. Please note that the shelf
included with STAND-TV03E cannot be
attached when two TVs are mounted.
110lbs
(49.90kg)
SINGLEDUAL
