Denali MA11768 User manual

866.527.7637 1 [e-mail]
DENALI Plow Mount
MA11768
CFMOTO U-FORCE 1000
Thank you for purchasing our DENALI plow mount. You now own a premium
custom plow mount to allow you to use your plow with your SxS. Please note the
following instructions and heed all warnings.
•Your UTV/SxS and/or plow system can cause death or injury, please use
caution and common sense when operating your unit.
•Read your Plow Operator Manual, your Winch Operator Manual, and all
warning labels before operating your UTV/SxS.
•Operate your UTV/SxS at a walking speed with the blade installed. Do not
exceed 5 mph (8 km/h), even with the blade up.
•Do not operate the UTV/SxS on slopes greater than 10 degrees with the
plow installed.
•Always lower the plow to the down position before leaving your UTV/SxS
unattended.
SEVERE INJURY OR DEATH MAY RESULT IF YOU ARE NEGLIGENT.

CF-Moto U-Force 1000
MA11768 22000 Industrial Blvd, Ste 250
Rogers, MN 55374
866.527.7637
866.527.7637 2 [e-mail]
Please verify that all hardware and parts are included in your package.
Kit Contents:
Item Number
Quantity
Part Number
1
1
MA11768 Mount
2
1
MA11768 U-Bracket
3
3
Hex Bolt M8x1.25x35
4
6
Plain washer, 8mm, narrow
5
3
M8x1.25 Nylock Nut
Figure 1

CF-Moto U-Force 1000
MA11768 22000 Industrial Blvd, Ste 250
Rogers, MN 55374
866.527.7637
866.527.7637 3 [e-mail]
MA11768 Plow Mount Installation
Note: Only use hand tools.
1. Remove two M6 bolts located at the front of the skid plate, as shown in Figure 2
Figure 2
2. Put M8 bolts to U-bracket and mount loosely.

CF-Moto U-Force 1000
MA11768 22000 Industrial Blvd, Ste 250
Rogers, MN 55374
866.527.7637
866.527.7637 4 [e-mail]
3. Fit the U Bracket over the frame of the machine, as shown in Figure 3
Figure 3

CF-Moto U-Force 1000
MA11768 22000 Industrial Blvd, Ste 250
Rogers, MN 55374
866.527.7637
866.527.7637 5 [e-mail]
4. Secure the mount using the two (2) M6 bolts that were removed from skid plate
and tighten all bolts, as shown in Figure 4
Figure 4
After First Time Use
Retighten all hardware as your frame may have flexed and the Plow Mount
loosened.