
INSTRUCTION MANAUL
TC-22
www.denver-electronics.com
LOCATION OF CONTROL
1. FUNTION SELECTOR
2. VOLUME CONTROL
. CD DOOR
4. BAND SELECTOR
5. TUNING CONTROL
6. DIAL POINTER
7. OPEN / CLOSE
8. LED DISPLAY
9. PROGRAM
10. SKIP -
11. STOP
12. REPEAT
1 . SKIP +
14. PLAY / PAUSE
CD OPERATION
PROGRAM
Up to 20 tracks can be programmed for disc play in any order.
Be sure to press the “STOP” button before use.
1.Press the ”PROGRAM” button, the display will show ”01” and flash.
2.Select desired track by using the ”SKIP + ” or ”SKIP -” button.
. Press the ”PROGRAM” button again to confirm desired track into the program memory.
4. Repeat step 2 and to enter additional tracks into the program memory.
5. When all the desired tracks have been programmed. Press the “PLAY/PAUSE” button to
play the disc in the order you have programmed and the program indicator flashes.
6. Press the “STOP” button twice to teminate programmed play and the program indicator
will turn off.
REPEAT
Press the ”REPEAT” button before or during playing CD , a single track or all the tracks
can be repeated.
Each press switches the repeat mode as follows:
1 – REPEAT 1 (The repeat indicator is flashing)