Dickinson 15-150B User manual

www.dickinsonmarine.com ~ [email protected]
Form# 7.2-36
PEDESTAL MOUNT
PART# 15-150B
This mounting kit has been designed for use with your Dickinson BBQ. It
will fit the following products:
•Sea-B-Que Small
•Sea-B-Que Round
•Sea-B-Que Large
•Spitfire 180 Grill
While this BBQ mount is a very strong and durable mount, it is not
recommended to leave the Bar-B-Que attached to the mount whilst
underway, especially in rough seas. It is recommended to remove the BBQ
whenever the boat is moving as the high center of gravity could pull the
mount from the deck
Included Parts
1 Pedestal Mount column
1 Pedestal Deck Mount Bracket
1 H-Bracket
1 C Bracket BBQ Mount
2 ¼-20 Lockwashers
2 ¼-20 Acorn Nuts

www.dickinsonmarine.com ~ [email protected]
Form# 7.2-36
Instructions for Use
Assembling the Mount
1. Identify where you are going to install the mount on the deck and attach the pedestal
mount base to the deck by securing all the mounting holes (A) with deck screws.
2. Once the pedestal mount base is secure, twist the base of the pedestal mount column
into the base. Turn the column clockwise until it will not turn anymore.

www.dickinsonmarine.com ~ [email protected]
Form# 7.2-36
3. Place the C-bracket onto either set of the mounting studs on the pedestal column.
Which studs depends on the direction you would like your BBQ to face.
4. Place the ¼-20 lock washers over the studs
5. Tighten the ¼-20 acorn nuts onto the studs using a 7/16
th
wrench or socket.
Attaching the H Bracket:
Remove the 10-32 nuts on the studs on the bottom of the drip tray holder then place the
“H” bracket onto the studs in the position indicated below and then tighten the nuts onto
the studs with a 3/8ths socket.

www.dickinsonmarine.com ~ [e-mail]
Form# 7.2-36
CAUTION
LATCH CAN BE EASILY
DAMAGED ON FIRST USE
When you are first installing your new Dickinson BBQ
mount, DO NOT hook the end of the latch onto the end of
the mount bracket. This can cause damage to the latch and
invalidate your warranty.