Digimax KIT-101JDHX30BP1U1 User manual

10_1”W 1280 x 800 TFT + Pap Touch
KIT FOR UP Board
KIT-101JDHX30BP1U1
Assembly guide
Rev 01
5 May 2016

Version
and
Date
Page
Old Description New Description
Remark
0_1
May 05
2016
All
First Edition Specification
Record of Revision

Kit Components
P/N Description
A
DSAM-101JDHX30BP1U1 1280x800 TFT lcd with LVDS interface & ROCKTOUCH 10.1”W 3 mm USB Pcap
Touch Screen
B
TFC_UP2DSI FutureLabs DSI-LVDS board
C
CB_UP2USB8 USB Bridge Cable
D
CBL-41-03-100-A DSI Cable 41 pins
E
/4 bolts, 4 nuts, 4 screw
F
CB_UP2IPEX101 LVDS Cable for TFT 10.1”W

Package KIT-07X0ETTX30003U1

Bring the Display with touch and align
from back side with the DSI converter
board, open the 4
PINS ZIF connector on
the DSI board
After you plug in the 4 pins Touch FPC into
the 4 pins ZIF connector, then bring the
LVDS Cable and
plug in the white
connector side on DSI converter board
then the Golden side on
the Display
Connector, make sure the side is correct
and is all plug in
Assembly Procedure

Then plug in the DSI Cable, make sure the
contacts are on the TOP side
Open the DSI 41
Pin connector from the
back side
After you plug in the DSI cable, your
solution will look like the following picture
Assembly Procedure

The USB Cable will look
like this picture
And then you can
fix the 4 spacer with
the 4 nuts
Plug in the USB bridge Cable on the 10 pin
side on the DSI board
Then
plug in on the top the UP board and fix with the remain 4 screws and plug in the
DSI and USB Cables
Assembly Procedure

Make sure
cables are plug in correctly on
the UP board
Put the UP board on the Bottom side
As following image.
Connect the HDMI cable to an External
LCD monitor and Plug in the power
supply on the UP board
Assembly Procedure

Once the UP logo will show on the Monitor please press DEL and you will enter into the
BIOS, once you are into the BIOS go on Chipset menu North bridge and select:
MIPI Port: Enable
Panel Type: 1280x800 for 10_1’W
Select Save Changes and Reset, now
you can disconnect the HDMI cable from UP
board.
Assembly Procedure

Done! You will see the panel light up and touch will work out of the box.
For the
best Touch behavior please connect the LCD metal Frame to the board Ground.
Assembly Procedure