Digimerge MNTV2XB User manual
136.8mm
136.8mm
50.5mm
Weight: 0.8kg / 1.76lb
MNTV2XB - Junction Box Mount
DIMENSIONS
PARTS OVERVIEW
CONTENTS
(See step 4 on reverse for compatibility with Digimerge cameras and accessories)
1 x Junction Box (IP66)
1 x Mounting Template
4 x Junction Box Mounting Screws (PWA4x30)
4 x Rubber Mounting Screw O-Rings
5 x Cover Screws (Silver PM4x8)
4 x Short Camera/Accessory Mounting Screws (PM4x8)
4 x Long Camera/Accessory Mounting Screws (PM4x14)
1 x Conduit Key
2 x Cable Holders
Conduit Seal Caps
3/4"-14 NPS (Preattached)
Conduit Key
Junction Box
Mounting Screws
with Rubber O-Rings
Top Plate Rubber
Seal (Preattached)
Conduit Seal O-Rings
(Preattached)
Back Box Hinge Screw
Cover
Screws
Cable Plate (Preattached;
see reverse for details)
Cover
MNTV2XB_INSTALLATION DIAGRAM_EN_R1
Cable Holders
Short Camera
Mounting Screws Long Camera
Mounting Screws
MNTV2XB_INSTALLATION DIAGRAM_EN_R1
INSTALLATION
Cable Plate Screws
Rubber seal
(Preattached) Cable Plate
Cable Holders
1. Remove the hinge screw (1x) and remove the cover
from the back box. If running cables through the side
conduit holes, ensure a conduit cap and o-ring is fitted to
the rear of the junction box.
2. Use the included mounting template to drill holes. Attach
junction box to surface using the junction box mounting
screws (4x) with o-rings attached.
3. Turn cover over and remove the cable plate screws (4x)
to remove the cable plate. This opens up the cable gap in
the cover. Run the cables through the cable gap and
camera housing/mounting bracket (depending on model).
4. Install the camera or mounting bracket to the cover using
the camera mounting screws (PM4x8 or PM4x14). See the
table below for a list of compatible Digimerge products.
5. Reattach the cable plate to the cover, ensuring that the
rubber seal is in the correct position.
6. Attach the cover to the back box using the hinge screw (1x).
Make sure that the TOP marking on the cover is pointing up
from the ground when installed. The camera can now swing to
the side of the junction box.
7. Connect the cables inside the junction box. Use the cable
holders to hold the cables in place during a ceiling installation.
8. Slide the cover into place over the junction box, ensuring
that the rubber seal is correctly in place. Insert the cover
screws (3x) to attach cover to junction box.
Mounting Holes Symbol Compatible Digimerge Products
Dome DPV34D, DPV24D, DPV24DL,
DPV24TLX, DNV14TL2,
DPD23D, DPD24D, DPD24DL,
DPD34D
WARNING -
Make sure to install in a location that can support the weight of the junction box, camera, and accessories.
To ensure a waterproof seal, make sure the TOP marking on junction box points up from the ground when
installed and that o-rings/rubber seals are attached properly to mounting screws, conduit caps, and junction box.
Hinge
Screw
Mounting
Screw Holes
12
3
4
6
8
Bullet
Dome Bracket MNTV2XW, MNTV2XC
DNB14TL2, DPB34TLX
7
