Digital Watchdog DWC-P20CM2 User manual

DWC-P20CM2
Ceiling Mount Bracket for Dome Cameras
Quick Start Guide
WHAT’S IN THE BOX
Ceiling Mount
Bracket 1 Set QSG Manual 1 Set
Attention: This document is intended to serve as a quick reference for initial set-up.
It is recommended that the user read the entire instruction manual for complete and proper installation and usage.
NOTE Download All Your Support Materials and Tools in One Place
1. Go to: http://www.digital-watchdog.com/support-download/
2. Search your product by entering the part number in the ‘Search by Product’ search bar. Results for applicable part numbers will
populate automatically based on the part number you enter.
3. Click ‘Search’. All supported materials, including manuals, Quick Start Guides (QSG), software and rmware will appear in the results.
Tel: [phone]
Technical Support Hours: 9:00AM – 8:00PM EST, Monday thru Friday
digital-watchdog.com

A. Attach the mount base ( ) and plate ( ) to the ceiling or wall using the supplied M6 tapping
screws ( ) and plastic bushings ( ).
B. Wind Teon tape around both threaded ends of the pipe (about 20 times) for sealing. If necessary,
use a silicone rubber sealant to seal the area where the mount base and the pipe meet.
C. Fit the pipe (of which threads are covered by Teon tape) into the mount base ( ) and turn until it
is securely fastened.
D. Pull all the required cables through the mount base ( ) and pipe ( ).
E. Align the dome adaptor ( ) with the pipe and turn until it is securely fastened.
F. Fasten the mount base ( ), dome adaptor ( ) using the set screw.
G. Fasten the vandal proof dome housing to the dome adaptor ( ) using M6 x 12 machine screw.
INSTALLING THE MOUNTING ACCESSORY
Rev Date: 02/17
Copyright © Digital Watchdog. All rights reserved.
Specications and pricing are subject to change without notice.
Quick Start Guide
5
6
6
6
6
1
1
1
1
4
3
2
Without Junction Box
1
4
3
2
Cable
With Junction Box
1
2
Cable
Junction Box
Seal around the mount base
tightly using silicon rubber
5
1
How to install the plate
Specications Dimensions (mm)
1. Cable passing through the wall 2. Cable on the wall (Remove the conduit
knockout for cable passing through)
3. Cable passing through the
wall with the junction box
(Attention to the plate side)
Cable
Mount
Base
Plate
Cable
Junction
Box
Mount
Base
Plate
Cable
Mount
Base
Plate
Knockout
Mount Base