Display Mount Pro GS-002-WALL User manual

English
Installation Instruction
1
UNPACKING INSTRUCTIONS
! Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
! Check package contents against the Supplied Parts List in the next page to assure
that all components were received undamaged. Do not use damaged or defective
parts.
! Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
! Install and operate this device with care. Please read this instruction before
installation, and carefully follow all instructions contained herein. Use proper safety
equipment during installation.
! Please call a qualified installation contractor for help if you don't understand these
directions or have any doubts about the safety of the installation.
Do not use this product for any purpose or in any configuration not explicitly specified
in this instruction. We hereby disclaims any and all liability for injury or damage
arising from incorrect assembly, incorrect mounting, or incorrect use of this product.
Fits most monitor size: 13"-27"
Load weight: 3.3~15.4 lbs (1.5~7 kg)
VESA: 75 x 75 and 100 x 100

Supplied Par ts List
2
(1)Allen Key-i(8)M4 Spacer-h(8)M4x30 Bolt-g
(2) Arm Set-a
(8)M4x12
Thumb Bolt-f
(4)M6x8 Bolt-e(1)Wall Plate-d
(4) M6x60 Lag Bolt-b (4) M8x50
Concrete Anchor-c
(4)Bolt Cover-j

60mm
3.8mm
Brick Mount
Step 1 Mounting the Wall Plate to the Wall
3
Wood Mount
50mm
60mm
8mm
b
d
d
c
b

Step 2 Attaching the Arm Sets to Wall Plate
4
Step 3 Removing the Security Nut and Taking Down the VESA Plate
2.1
2.2
2.3
ae
2.4
Security Nut
j
2.5

5
Step 4 Attaching the VESA Plate to the Monitor
For Monitor with Curved or
Recessed Back
h
g
Step 5 Sliding the Monitor onto the Head of Arm Set
Install the Security Nut. Make sure
the security nut is installed before
you rotate the monitor.
Slide the monitor onto the head of
Arm Set(a) as shown in the above
diagram.
For Monitor with Flat Back
f
Security Nut

Step 6 Setting the Tilt Angle Position
6
6.1
6.2
6.3
i
Step 7 Adjusting the Torque of Gas Spring
Adjust the torque of gas spring according to the weight of your monitor. If your monitor
can not stay in the lower position, turn the grub screw clockwise(-). If your monitor can
not stay in the higher position, turn the grub screw counterclockwise(+). Keep turning
until monitor position can be raised and lowered easily.
+
-
i

7
Finish Technical Drawing
Step 8 Managing the AV Cables
8.1
8.2
8.3
8.4
i
i