Display Mount Pro GS352D User manual

English
Installation Instruction
1
UNPACKING INSTRUCTIONS
! Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
! Check package contents against the Supplied Parts List in the next page to assure
that all components were received undamaged. Do not use damaged or defective
parts.
! Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
! Install and operate this device with care. Please read this instruction before
installation, and carefully follow all instructions contained herein. Use proper safety
equipment during installation.
! Please call a qualified installation contractor for help if you don't understand these
directions or have any doubts about the safety of the installation.
Do not use this product for any purpose or in any configuration not explicitly specified
in this instruction. We hereby disclaims any and all liability for injury or damage
arising from incorrect assembly, incorrect mounting, or incorrect use of this product.

Supplied Par ts List
2
CAUTION!
WARNING
!This monitor desktop mount must be securely
attached to the horizontal desk. If the mount is
not properly installed it may fall, resulting in
possible injury and/or damage.
Tools Required Phillips Screwdriver
(1) 35mm Tube Support-a (2) VESA Plate with
Gas Spring Arm-c
(8)M4 Space-n(8)M4x30 Bolt-m
(1) Disconnected
“C” Clamp-b
(2)M10x15 Bolt-j (1)Allen Key-k(4)M6x12 Bolt-i(6)M4x6 Bolt-h
(2)Add-on Arm-d (2)Wire Cover-e (4)Axis Cover-f (1)Stopper Ring-g
(1)Arm Connector-o
(8)M4x12
Thumb Bolt-l

Step 1 Install the “C” Clamp According to the Desktop Thickness
3
Step 2 Install Stopper Ring to the Tube Support
a
b
j
k
gk
The depth of “C” clamp can be changed in
three positions. Choose the proper depth
acc o r di n g to t he thi c k ne s s of y ou r
desktop. Connect it by 2pcs M10x15
bolts(j), using the supplied Allen Key(k).
Install Stopper Ring(g) to the
Tube Support(a), fasten the
grub screw by supplied Allen
Key(k).
Grub Screw
a

4
Step 3 Assemble Two Arms and Wire Cover
For Curved Back Monitor
Step 4
Step 5
Install Arm to the Tube Support
k
Mount the Monitor to VESA Plate
m
n
c
d*
f
ih
e
f
i
o
*The Add-on Arm(d) can be removed as another option if you use stand for the
smaller screens on a desk that is against a wall.
For Flat Back Monitor
l

Step 7 Adjust the Torque of Gas Spring
k
Adjust the torque of gas spring according to the weight of your
monitor. If your monitor can not stay in the lower position, turn the
grub screw clockwise(-). If your monitor can not stay in the higher
position, turn the grub screw counterclockwise(+). Keep turning
until monitor position can be raised and lowered easily.
5
Step 6 Make Necessary Adjustments, and Run Cables
Thank you for choosing our products!
Fix Tilt
Angle