
Controls and Operating
8
INERTIA SEAT BELTS – Fig. 8
Warning System
The seat belt warning light Fig. 8 will glow
when the ignition is switched on and either
seat is occupied with the seat belt
unfastened, a warning buzzer will also
activate for approximately ten seconds.
Wearing
Always wear the seat belt as a diagonal
assembly, until the lap section is comfortably
tight.Check that belt is lying flat and is not
twisted.
The belt is intended to be worn by occupants
of adult build. Under no circumstances must
it be used for more than one person, even for
small children.
Withdraw the belt from the reel with a steady
pull, sudden snatches will lock the reel.
To fasten, pull the belt over the shoulder and
hips, Fig. 9 and press the tongue into the
lock nearest the wearer Fig. 10. A click will
indicate that the belt is locked.
To release, push the ‘PRESS’ button on the
lock. Stow the belt by allowing it to retract
fully, manually assisting the last few inches.
Care of Seat Belts
Regularly inspect the seat belt webbing for
signs of abrasion or wear, giving particular
attention to fixing points and adjusters.
Renew a seat belt assembly which is in any
way damaged or which has withstood the
strain of a severe impact.
Do not attempt to make any alterations or
additions to the seat belts or fixings as this
could impair their efficiency.
Use the seat belt at all times – even on a
short journey.
Clean seat belt by sponging with warm water
and non-detergent soap. Allow to dry
naturally.