Drone-Clone Xperts Drone X Pro Xtreme Manual

1
Drone-Clone Xperts Ultimate
INSTRUCTIONS GUIDE for your New
Drone X Pro XTREME
(If Instructions are too small to read, press Ctrl + on Keyboard to ZOOM in)
Table of Contents
Quick Start Instructions ................................................................................................................................2
Calibrating Drone-Clone Xperts Drone X Pro XTREME: Step by step guide .........................................3
Calibrating the Drone X Pro XTREME by remote controller ............................................................4
Calibrating the Drone X Pro XTREME by phone APP ......................................................................5
*Fine-Tuning (“Trimming”) your DXP XTREME.............................................................................................6
Connecting Drone X Pro XTREME to WiFi.....................................................................................................8
NOTE:
*NECESSARY INSTRUCTIONS for OPTIMAL CONTROL Fine-
Tuning (“Trimming”) your DXP XTREME (PAGE 6)

2
Quick Start Instructions

3
Calibrating Drone-Clone Xperts Drone X Pro XTREME:
Step by step guide
Sometimes after minor crashes, drones start
to fly abnormally even if there are no physical
damages (like faulty propellers). Performing
gyro-calibration can solve sideward flying or
other flight disorders.
You can reset the Drone X Pro XTREME’s gyro
settings in two different ways, either using
the remote control or through the JY UFO
phone APP (available for DL on virtually all
smartphones with WiFi access).

4
Calibrating the Drone X Pro XTREME by remote
controller
•Step 1: Turn on the remote controller;
•Step 2: Long press the power switch
(located on top of drone) to turn ON your
Drone X Pro XTREME;
•Step 3: Place the drone on a horizontal
surface.
•Step 4: Bind the transmitter with the drone
by pushing the throttle (left joystick) up to
the highest position, and then pulling it
straight down to the lowest position .
Solid light will indicate successful bind.
•Final Step: Move both sticks to lowest right
corner (like in the image above) for about 2-
3 seconds. LED lights will start to flash
rapidly. Wait a few seconds till the lights are
solid again and you are done.

5
Calibrating the Drone X Pro XTREME by phone APP
Calibrating the Drone X Pro XTREME through
APP is even easier. After you connected to
drone with your phone. You need to enter the
settings menu (like in the image bellow) and
select the “Gyro calibrate” icon. First, the
LEDs will start to flash rapidly, then turn
solid. Finish! That was all, you are done and
ready for your next flight!

6
**Fine-Tuning (“Trimming”) your DXP XTREME**
Video Link to Download Trimming Drone X Pro XTREME-Trim Instructions.MOV
This section is starred because the absolute BEST Tip for Beginner Drone
Pilots is learning how to fine-tune their drone by using the “TRIM”buttons.
These buttons will give you optimal control of your Drone X Pro XTREME.
When used correctly, your drone will steadily hover in one location without
drifting.
If your drone starts drifting in a certain direction directly after take-off
DON’T PANIC! Everything is COMPLETELY NORMAL. All you have to do
is TRIM this drone in the opposite direction.
Trimming Examples
Q) After take-off, my drone DRIFTS TO THE RIGHT
A) Trim Drone to LEFT using LEFT Trim button
Q) After take-off, my drone DRIFTS FORWARDS
A) Trim Drone BACKWARDS using DOWN Trim button

7

8

9
Connecting to WiFi & Downloading JY UFO APP

10
Connecting Drone X Pro XTREME to WiFi

11
microSD Card Slot Location