
INSTALLATION OF THE FAUCET
1 Fastening Deck-Plate (optional)
The included base-plate gasket can be
installed directly on the sink without any
adhesive agents. However, if desired apply
plumbers putty or silicone to the bottom
edges of the base-plate gasket. Once
applied, align base-plate gasket and press
into place to firmly attach to sink. Remove
excess plumbers putty or silicone and
place deck-plate onto base-plate gasket.
See images below. If installing on a one-
hole sink installing the deck-plate is
optional.
2 Install Faucet on Sink Top
Set the faucet in place on the sink top,
inserting the inlets through the sink hole, and
press down. Next, attach the washers and
locknuts on the faucet inlets and tighten. Be
careful not to over tighten. Use optional
mounting screws if unable to tighten locknut
due to space limitations.
3 Weight Assembly
With the hand spray seated in spray holder,
assemble weight assembly onto spray hose
by slipping weight over the hose.
4 Install Pull Out Sprayer Hose
Next, connect end of spray hose under sink
to stainless steel hose on faucet.
5Hose Attachment
Attach stainless steel water supply hoses to
water supplies with appropriate connectors.
Connect left tube to hot and right tube to
cold. Test faucet by turning on water
supplies and checking all connections for
leaks.
6 Test Sprayer
Pull hand spray from spray holder and
direct spray into the sink. Operate faucet
handle up and down in HOT and COLD
positions to flush water lines thoroughly.
Place hand spray into spray holder and
operate handle and check all connections
for leaks. Check hand spray operation.
Push button for gentle spray. Push button
again for aerated stream.
MAINTENANCE AND CLEANING
Cleaning Tips: The finish on your product is
designed to retain its beautiful sheen for
years. To maintain the original look of the
finish, a little care and caution should be
used. We recommend the use of mild soap
and water to clean the product.
THE USE OF ABRASIVE CLEANERS MAY
SCRATCH THE FINISH OR CAUSE OTHER
DAMAGE.
RECOMMENDED TOOLS AND
MATERIALS
¨ Adjustable Wrench
¨ Plumbers Tape (Thread Seal
Tape)
¨ Plumbers Putty
BEFORE YOU BEGIN
There are a variety of things to do before
installing any new plumbing system into
your home or residence. Before you begin
work make sure you:
¨ Shut off the main water supply
¨ Cover your drain to prevent loss
of parts
¨ Observed any local plumbing
codes
¨ Inspect fixture for damage -
Replace as necessary
Dura Faucet reserves the right to make any
revisions in the design of products without
notice.