
Assembly
1. Securely attach the mounting bracket to a wall or ceiling using the correct orientation as pictured. Only mount the fan to a
surface that can support its weight.
Note: The included heavy-duty screws are intended to mount the inline controller component only. Do NOT attempt to
mount the main unit with these screws. Only use hardware appropriate for the chosen mounting surface.
2. Slide the bolt located at the top of the yoke through the appropriate holes in the mounting bracket for the desired
mounting orientation.
3. Place the flat washer over the end of the bolt. Then thread the nut onto the bolt and tighten firmly.
4. If desired, attach the inline controller to a wall using the mounting hardware provided.
Operation
• Plug the power cord into a 120-volt power source.
• Adjust the position of the yoke and tilt the fan head to direct the breeze where needed.
• Select the desired fan speed setting or turn the unit OFF using the rotary dial on the inline controller.
– L = Low
– M = Medium
– H = High
High-performance DuraBreeze®equipment circulates and purifies indoor garden
air to keep it cool, clean and odor-free. For the superior DuraBreeze®experience,
please read the following instructions in full and observe all safety precautions
when operating this product.
READ AND SAVE THESE INSTRUCTIONS
Rev:92016
Specifications
Pro Wall Fan 18”
Volts: 120
Watts (low/med/high): 95/104.5/122
Amps (low/med/high): 0.81/0.9/1.1
To reduce the risk of fire, electric shock and/or personal injury:
• Do not use this fan with any solid-state speed control device.
• Do not operate the fan with a damaged cord or plug. Discard the fan or return to an authorized service facility for examination and/or repair.
ATTENTION
Pour réduire le risque d’incendie, de choc électrique et/ou des blessures:
• Ne pas utiliser ce ventilateur avec un dispositif de contrôle de vitesse à l’état solide.
• Ne pas utiliser le ventilateur avec un cordon ou la fiche est endommagé. Jeter le ventilateur ou retourner à un centre de service autorisé pour
examen et/ou réparation.
Safety Instructions
• Disconnect the fan from the power source before cleaning or servicing.
• Do not pull on the cord to disconnect unit from the power source. Always grip the plug and pull it from the outlet.
• Do not run the cord under carpeting. Do not cover the cord with throw rugs, runners or similar coverings. Do not route cord under furniture
or appliances. Arrange cord away from high-traffic areas where it will not be tripped over.
• Do not operate in the presence of explosive and/or flammable fumes.
• Do not leave children unattended near the fan.
• Do not use the fan outdoors.
• Do not expose the unit to water or rain.
• Do not operate with a loose fit between the plug and the outlet. A loose fit may cause the plug to overheat. Have a qualified electrician
replace the outlet if the plug does not fit properly.
Wall Mount
Nut
Nut
Flat Washer
Mounting Bracket
Bolt
Bolt
Yoke
Fan Head
Wall Stud
Ceiling Mount
Flat Washer
Mounting Bracket
Yoke
Fan Head
Ceiling joist
Warning