Econoco sellutions PS2CBADJ User manual

ADJUSTABLE 2-WAY CROSS BAR RACK ITEM#:PS2CBADJ
REVISED ON 7/14/2016
PAGE 1

WRENCH
HEX WRENCH
HANGBAR 1 X
TOP UPRIGHT 2 X
ADJUSTABLE CONNECTOR 2X
SET SCREW 2 X
BOTTOM UPRIGHT 2 X
CASTER 4 X
BASE 1 X
FACEOUT 2 X
INCLUDED PARTS AND TOOLS
PAGE 2

1
1
SCREW THE CASTERS INTO THE BASE AS SHOWN USING
WRENCH
PAGE 3

J
2
2
BY HAND, SCREW IN BOTTOM UPRIGHTS AS SHOWN
2A
TO FULLY TIGHTEN UPRIGHT, PLACE INCLUDED WRENCH
INTO PIPE SLOTS AS SHOWN. TIGHTEN FULLY.
2A
PAGE 4

G
H
FACING OUT
SET SCREW FACING OUT
3
3
BY HAND, SCREW ADJUSTABLE CONNECTORS TO
BOTTOM UPRIGHTS SUFFICIENTLY &
THEN ADJUST SO THAT IT ALIGNS AS SHOWN BELOW
4
4
TIGHTEN THE SET SCREW USING HEX WRENCH TO LOCK
ADJUSTABLE CONNECTOR IN PLACE.
PAGE 5

5
5
BY HAND, SCREW IN TOP UPRIGHTS TO HANGBAR AS SHOWN
PAGE 6

HAND WHEEL
6
6
(UNTIGHTEN HAND WHEEL)
DROP HANGBAR ASSEMBLY FROM STEP 7 AS SHOWN AT DESIRED HEIGHT
& LOCK IN POSITION BY TIGHTENING THE HAND WHEEL.
PAGE 7

7
7
SCREW IN FACEOUTS TO HANGBAR
PAGE 8