Edge Lighting Night Owl User manual

Installation Instructions for Night Owl (Plug-In Version)
904-NIGHTOWL-P-02
Install the Fixture
NIGHTOWL-P-_
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: [phone]
Fax: [phone]
www.edgelighting.com
[email protected]
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor locations.
- This product is for wall mount application.
- This instruction shows a typical installation.
IMPORTANT INFORMATION
A
COVER
1: Remove the cover by sliding it up and then off the backplate.
1
BACKPLATE
B
2: Hold the backplate against the surface where the fixture is
going to be mounted. Level the backplate vertically and mark
the two mounting holes on the surface.
MOUNTING
HOLE
MOUNTING
HOLE
BACKPLATE
WALL
2
2
© 2015 Edge Lighting. All Rights Reserved.

2
3: Tap the anchors onto the marked points into the wall up to
the threaded portion with a hammer.
4: Screw the threaded portion of the anchors in with the a
Phillips screwdriver.
C3
4
ANCHOR
WALL
DMOUNTING
HOLE
BACKPLATE
WALL
5
5
5: Mount the backplate to the anchors with the two #8 screws.
#8 SCREW
E
COVER
6: Replace and slide the cover down completely onto the
backplate.
6
BACKPLATE
F
7: Plug the power supply into the 120 volt power outlet.
PLUG-IN
120 VOLT
POWER OUTLET
7
NOTE: The fixture contains a 1 Watt integrated LED lamp. This
lamp is rated for 50,000 hours.
8: Use the rocker switch on the bottom of the backplate to
control intensity of the light.
NOTE: Omit steps 3 to 5 if installing the fixture onto a surface
other than drywall like bedroom wood board. Use the provided
screws to mount the backplate directly to the wood board.