Electrograph ELESAM42-SM User manual

INSTALLATION INSTRUCTIONS
PART NO. ELESAM42-SM
©2002
Printed in USA 08-02
ELESAM42-SM
Static Wall Mount
Prior to assembly, unpack carton completely and
verify contents. If you are missing any of the
following components, please contact Technical
Support at 1-800-776-5768.
(1) BRACKET, PLASMA MOUNTING, STATIC
(6) SCREWS, M8 X 35MM BUTTON HEAD CAP
(6) MOUNTING BUTTONS, NYLON STEPPED, PAN STYLE
(1) ALLEN KEY, 5MM
(2) LATCHING FLAG
(2) 10-24 X .5 FH UNDERCUT SCREW
(2) NYLON WASHER
(2) 10-24 NYLOCK NUT
READ INSTALLATION INSTRUCTIONS COMPLETELY BEFORE PROCEEDING
Figure 1
CAUTION: PLASMA DISPLAYS ARE EXTREMELY FRAGILE!
Mounting Button
Locations
10-24 x .5 FH
Undercut Screw
N
ylon Washer
between flag & mount
Latching Flag
(Note outer
hole location
)
10-24 Nylock Nut
installed from underside
Figure 3
1. Attach four mounting buttons to plasma using four M8 x 35mm button head cap screws
provided (see Figure 2
).
Figure 2
2. Secure two latching flags to Plasma Static Mount using one 10-24 x .5 FH Undercut
Screw, one Nylon Washer, and one 10-24 Nylock Nut for each flag (See Figure 3).

3. Securely anchor the plasma static mount to the wall using wall studs or supporting framework
(See Figure 4).
4. Make sure the flags are lowered before attempting to place the plasma on the mount.
5.
With the aid of another person, lift the plasma display up to the mount, align the mounting buttons
on the plasma with the teardrop slots in the mount, and set the plasma into place.
6. Position (raise) the flags
to secure the plasma.
Align Mounting
Buttons with
Teardrop Slots
Anchor to wall
using four slots
Figure 4