Rinstrum C520 Parts list manual

146.5mm
Deskstands can be secured to a bench or shelf.
Drill pilot holes 146.5mm apart and secure with No6 screws provided.
C500-601-100
C520 Desk Mount Brackets Usage Guide
Page 1 of 7

C500-601-100
C520 Desk Mount Brackets Usage Guide
Loosen the clamp screws in each of the bottom mount brackets, then swing the
brackets out horizontally.
Mount Bracket Clamp Screw
Page 2 of 7

C500-601-100
C520 Desk Mount Brackets Usage Guide
Slide the indicator onto the desk mount brackets between the mount bracket
and the front flange seal.
Screw the two bottom clamp screws in
to lightly seat into the desk mount
bracket.
Page 3 of 7

C500-601-100
C520 Desk Mount Brackets Usage Guide
Once the C520 indicator has a pair of deskmount brackets attached, it can be stacked
and ganged up to make a panel of indicators.
To Stack indicators:
Loosen the clamp screws in the
top brackets of the indicator to
be on the bottom of the stack.
Then swing the top brackets out
to horizontal.
Page 4 of 7

C500-601-100
C520 Desk Mount Brackets Usage Guide
Slide the top instrument’s desktop brackets
down between the swung out top mount
brackets of the base indicator untill the
bottom of the top indicator’s desktop
brackets rest on the top of the bottom
indicator.
lightly tighten the top clamp
screws of the bottom instrument
against the top instrument’s desk
stands
Page 5 of 7

C500-601-100
C520 Desk Mount Brackets Usage Guide
The C520 units can also
be ganged side by side.
Included with the
indicator are a pair of M3
x 50mm screws with nuts.
These can be used to
secure adjacent desk
stands together as
shown.
Page 6 of 7

C500-601-100
C520 Desk Mount Brackets Usage Guide
C520 indicators on their desk stands can be ganged and stacked in combination to make
a panel of indicators.
When stacking units they should be secured to the surface they are sitting on.
Page 7 of 7