Elfa CLASSIC User manual

Door & Wall Rack Assembly Instructions
Things Youʼll Need -
For Overdoor Hook Method: Level.
For Into Door or Wall Method: Level, Pencil,
Drill or Screwdriver, and Hardware.
Component Options:
Hardware Options:
Residential or
Commercial
Overdoor
Hooks
with
Hardware
77-3/4" or
94-5/16"
Mounted
Standard
Small Mesh
Basket
Medium Mesh
Basket
Large Mesh
Basket
Shoe Rack
Utility Pegboard
HELPFUL TIP
• If not using the overdoor hooks, please ask for the best installation hardware
for your specific needs.
Installing with Overdoor Hooks
• Place the short Residential or Commercial
Overdoor Hook (that has a bolt) over the
top of the door.
• Fit the second set of slots on the Standard
over the hook.
• Using a Level, adjust the Standard until it is
square to the floor.
• Attach the long Residential or Commercial
Overdoor Hook to the Standard under the
bottom of the door.
• Pull down to lock it in position. The bottom
hook should not be tight against the door.
• Use the included Allen Wrench to tighten
the top bolt.
Package of Ten
Wood Screws
Package of Five Hollow
Door Anchors and Screws
(Baskets are available in mesh and wire.
Ask a Specialist for assistance.)
Package of Five
Drywall Anchors
Gift Wrap Rack
Utility Pegboard Boxes
Utility
Pegboard
Hooks
(Multiple sizes to choose from)
(Multiple styles
to choose from)

Door & Wall Rack Assembly Instructions
(continued)
©2023 The Container Store Inc. All rights reserved. WF227200 06/23
For assembly video, visit containerstore.com/elfa/installation.htm
Complete Solutions:
Installed Using Overdoor Hooks
Installed into a Door
Installed into a Wall
Installing into a Hollow Door or Drywall
Adding Assessories
Installing into a Solid Door or Wall Studs
• Align the tabs on the back of Accessory
with the slots on the Standard.
• Pull down to hook in place.
• Repeat the process with all Accessories.
• Drill holes using a 1/4"/7mm drill bit and
insert Hollow Door Anchors or Drywall
Anchors.
• Insert screws into anchors and tighten.
• Drill a pilot hole with a 1/10"/2.5mm drill
bit at each marked spot.
• Screw Standard to the door or wall with
wood screws.
• Mark screw placements.• Position Standard on door or wall. Using a
Level, adjust the Standard until it is square
to the floor.
• Position Standard on door or wall. Using a
Level, adjust the Standard until it is square
to the floor.
• Mark screw placements.