Elkay MPW201 User manual

PAGE1 98374C (12/07)
MPW201
To assure you install this model easily and correctly,
PLEASE READ THESE SIMPLE INSTRUCTIONS BEFORE STARTING THE
INSTALLATION. CHECK YOUR INSTALLATION FOR COMPLIANCE WITH
PLUMBING, ELECTRICALAND OTHERAPPLICABLE CODES.After installation,
keep these instructions for future reference.
IMPORTANT
ALL SERVICE TO BE PERFORMED BYAN AUTHORIZED SERVICE PERSON
Installer
Mounting Plate Instructions
Model MPW201
Parts List
Refer to the illustration to make sure you receive all mounting plate parts. If any parts are missing contact
your local distributor or call 1.800.260.6640.
PART NO. DESCRIPTION
28794C
70020C
75541C
75708C
Mounting Plate
Hex Nut 5/16-18
Flat Washer .339/.359ID
Threaded Rod 5/16-18 x 6 In.
1
2
3
4
ITEM NO. QTY.
1
28
28
7
34
2
1
This Mounting Plate System is designed for use with the following models:
EDFP220RC and 7120 Ftn.

PAGE298374C (12/07)
MPW201
FOUNTAIN
FINISHED FLOOR
16 1/2"
419mm
12 1/2"
318mm
FINISHED WALL
MTG. PLATE
MTG. HOLES
MTG. HOLES MTG.
HOLES
FINISHED WALL
27"
686mm
*
5/8"
16mm
10 3/4"
273mm
25 1/16"
637mm
MTG. HOLES FOR
THREADED RODS
When mounting plate directly to wall studs please refer to the
diagrams shown below. For electrical, waste, and water supply locations please
refer to the Installation/Owners manual.
3/8" MTG. HARDWARE
(SUPPLIED BY OTHERS)
* ADA REQUIREMENT
NOTE - AFTER INSTALLATION, THREADED RODS MAY NEED TO BE TRIMMED

PAGE3 98374C (12/07)
MPW201
REPAIR SERVICE INFORMATION CALL TOLL FREE NUMBER 1.800.260.6640
5/8"
16mm
3 1/4"
83mm
4 1/2"
114mm
1/2"
13mm
2"
51mm 2 1/2"
64mm
.50 x .75 OBROUND (4)
DETAILA
MTG. HOLES FOR
THREADED RODS
When using mounting plate with ML100 (Support Columns) please refer to the
diagrams shown below. For electrical, waste, and water supply locations please
refer to the Installation/Owners manual.
MTG. HOLES
MTG. HOLES MTG. HOLES
29"
737mm
FINISHED FLOOR
FINISHED WALL
3 3/4"
95mm
SEE DETAIL A
MTG. PLATE
INSTALLED BEHIND
FINISHED WALL
**
27"
686mm
*
25 1/16"
637mm
5/8"
16mm
10 3/4"
273mm
U-BOLTS ARE INCLUDED WITH
ML100 (SUPPORT COLUMNS)
* ADA REQUIREMENT
** WITH STANDARD STUD LENGTH OF 6 INCHES.
NOTE - AFTER INSTALLATION, U-BOLTS AND THREADED RODS MAY NEED TO BE TRIMMED