Ella Grace 10 User manual

fig.5
B
Afig.6
C
D
fig.2fig.1
Fixing Holes - 10mmØ Fixing Holes - 6mmØ
fig.4
fig.3
D
E
fig.7 fig.8
F
G
fig.9
10°
1000 mm
GRACE 10

Assembly & Installa�on
Step 1() Fix the upper wall bracket on a solid wall or pol If you have any doubts consult a
profession The advised hht to x the upper wall bracket is +/- 2000mm (this heiht depends on the
hht of the operator)
Step 2() Slide the main support arm into the upper wall bracket
Step 3() Fix the lower wall bracket to the wall approximately 000mm below the upper wall bracket
Step 4 () Assemble lower wall bracket
Step 5( Lithe main support arm to its horizontal posinInstall pole support clip (A) and test
telescopic slide by liinlever (B)
Step 6() Slide the Umbrella head and pole into the end clampEnsure that the Umbrella is
orientated with the push buon (D) to the frontCheck that the t is neat, then hten knob (C)
Step 7() To open the Umbrella - Press buon (D) and pull down on the Umbrella pole so that the
Umbrella is completely openNote that the hined elbow joint (E) must be clear of the main support arm
clamp, then swinthe pole up into the pole support clip
Your Grace 10 Umbrella is now assembled and ready for use.
Opera�on
Telescopic Arm 1400-1800mm: To adjust the extension lenth, lilever (B) and slide the Umbrella in or
out to the desired posion
Horizontal swing: 8) Turn the handle (F) an-clockwise to loosenWhen the Umbrella is swuninto
its desired posion, turn the handle clockwise un ht to lock the Umbrella posionf the handle has
been turned a full rotaon and it is sl not ht, you can pull down on the handle so that it is in free mode
and twist it back before releasinthe handle allowinit to sprinback up and hten further
Umbrella Tilt: ()Pull on knob (G) and the Umbrella will lt 0 dees into its t posinTo set the
Umbrella back in its standard posiply pull on knob (Gn and lithe Umbrella unl it locates
back in its standard posi
Closing the Umbrella: If s extended, slide the telescopic arm back into its closed posionove the
Umbrella pole from support clip (A) and swindown so that it han vercallyPress buon (D) and push
the pole up un it clicks into its closed posinWhile sholdinonto the pole, pull knob (G) and lie the
Umbrella t inst the main support armNow lithe main support arm so that it slides partway up and
out of the upper wall bracket exposinthe pivot pointThe Umbrella can then be lowered down so that it
locates into the lower wall bracket
Always close your  when not in u
GRACE 10