Enclume S RACK PR17 User manual

Enclume “S” RACK
PR17
Enclume racks are the ultimate in
Storage racks made.
WARNING:
READ ALL OF THE INSTRUCTIONS
BEFORE ASSEMBLING AND USING
OUR RACK.
All of our hammered steel racks are finished with an industrial wax designed to
give years of protection to the rack. Cleaning is easily done with a damp cloth. Dry
thoroughly after cleaning. If a touch-up is ever needed we recommend a "Pledge"
like wax product.
Enclosed you will find everything needed for the assembly
and use of your storage rack. Two people make assembly
and installation easier. The parts and hardware included are:
Hardware included:
1 –Ceiling Screw Hooks
1 –Allen wrench
Toggler Kit
Components included:
1 –Assembled Rack
1 –Hanging Hook
12 –Angled Pot Hooks
See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS
Limited Warranty:This product is warranted to be free of material defects for a period of five years from the date of purchase. Customer's exclusive remedy shall
be the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the
warranty period and (2) customer returns the defective product to Enclume Design Products, Inc. , 24 Colwell St.. , Port Hadlock, WA 98339, postage prepaid
within 20 days following a return authorization number (which may be obtained by telephoning the number at the bottom of this instructions) being provided to the
customer by Enclume. There are no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES
ARISING OUT OF THE PURCHASE OR USE OF ENCLUME'S PRODUCTS.

ASSEMBLY AND INSTALLATION INSTRUCTIONS for PR17
Enclosed you will find everything needed for the assembly
and use of your storage rack. Two people make assembly
and installation easier. The parts and hardware included are:
Hardware included:
1 –Ceiling Screw Hooks
1 –Allen wrench
Toggler Kit
Components included:
1 –Assembled Rack
1 –Hanging Hook
12 –Angled Pot Hooks
ASSEMBLY AND INSTALLATION INSTRUCTIONS
Rack Assembly
1) It is best to keep the tissue on during installation to avoid fingerprinting.
2) Your cookware rack has been shipped assembled. Please check that all the buttonhead screws have remained tight during
shipping. A wrench is provided.
3) We recommend that you anchor your rack into the solid wood of ceiling joists or beams. Carefully measure the area where the
rack is to be hung and install the ceiling screw hooks directly into the wood joists. If it is not convenient to hang your rack
directly into wood joists you may use the new-technology DRYWALL anchors enclosed with your rack. The steel anchors are
very strong and when installed in drywall will hold 200 lbs. each. Two anchors hold about 400 lbs. Follow the instructions in
the Toggler kit.
4) A hanging hook has been provided to lower the rack to a convenient working height. Simply suspend it from the ceiling screw
hook and hang the rack from it.
5) Your rack is now ready to use. Distribute the weight of your cookware evenly around the rack.
6) The care and cleaning of our copper and brass units must be done with a low abrasive cleaner such as “Flitz”. Chrome racks are
best cleaned with a good quality glass cleaner like “Windex”. Our high quality plating will age and tarnish the same as solid
material. A periodic cleaning will restore your rack to its original brilliance.
It is important that your rack is assembled correctly. If the unit is assembled or used incorrectly, it
could become unstable and collapse, possibly causing injury.