Enclume DR20 Instruction manual

DR20-Small Rectangle Rack
Décor Low Ceiling
Enclosed you will find everything needed for the assembly
and use of your hearth rack. Two people make assembly
and installation easier. The parts and hardware included are:
Hardware included:
4 – 5/16” x ½” Button Head Screws
4 – 2” Lag Screws (for wood mounting)
1 – 3/16” Allen Wrench
Toggler Kit
Components included:
4 – Low Ceiling Arms
1 – Rack Body Square
1 – Hanging Grid
4 – Grid Brackets, EGB
12 – Straight Pot Hooks, EPHS
See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS
Thank you for choosing Enclume!
Enclume racks are the ultimate quality,
design, strength and function.
WARNING: READ ALL OF THE
INSTRUCTIONS BEFORE
ASSEMBLING AND USING YOUR
RACK
If you need help, please call 1-877-ENCLUME
Enclume Design Products
24 Colwell Street, Port Hadlock, WA 98339
Phone [phone] Fax [phone]
www.enclume.com

ASSEMBLY AND INSTALLATION INSTRUCTIONS
Rack Assembly
1) First, locate the four low ceiling arms. Using the four 5/16” x ½” button head screws attach the arms to the outside of the
rack body square – as shown in the assembly diagram. Do not fully tighten the button head screws at this time. Note: that
the Enclume medallion should be facing up on the outside of the rack body.
2) Place the rack on a flat surface to level and set the arms to straight – then tighten all screws to final positions.
3) We recommend that you anchor your rack into the solid wood of ceiling joists or beams. Carefully measure the area where
the rack is to be hung and install the ceiling screw hooks directly into the wood joists. If it is not convenient to hang your
rack directly into wood joists you may use the included DRYWALL anchors enclosed with your rack. See Toggler® brand
manufacturer recommendations for weight limits included in the instructions in the Toggler kit.
Grid Assembly
4) Place the four grid brackets over the sides of the rack, just inside each of the low ceiling arms with the straight end of the
brackets facing towards the inside of the rack. Next place the grid on top of the grid brackets and distribute the hooks on the
rack.
5) Note: The grid should be placed on the grid brackets so that the grid crossbars that extend the width of the grid are facing
down. This will help to keep the grid from sliding out of position when the rack is in use.
It is important that your rack is assembled correctly. If the unit is assembled or used
incorrectly, it could become unstable and collapse, possibly causing injury.
WARNING
Limited Warranty: This product is warranted to be free of material defects for a period of five year from the date of purchase. Customer's exclusive remedy shall
be the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the
warranty period and (2) customer returns the defective product to Enclume Design Products, 24 Colwell St., Port Hadlock, WA 98339, postage prepaid within 20
days following a return authorization number (which may be obtained by telephoning the number at the top of this instructions) being provided to the customer by
Enclume. There are no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PORPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING
OUT OF THE PURCHASE OR USE OF ENCLUME'S PRODUCTS.