Endon Renner 6-Light Flush Fitting User manual

Renner 6-Light Flush Fitting
Safety Warnings
INSTRUCTION MANUAL
• Thisproductisonlysuitableforconnectiontoa240V~50HzsupplyinaccordancewithcurrentIEEwiring
RegulationsandshouldbeinstalledinaccordancewithlocalBuildingRegulationsandisforDomestic
indoorceilinguseonlyandnotsuitableforaBathroomlocation.
• Thelightttingshouldbeconnectedtoalightingcircuitprotectedbya5ampfuse(ora6ampminiature
circuitbreaker).
• ThisproductisaClassIttingandmustbeEarthed.
• Ifindoubtwerecommendyoucontactaqualiedelectrician.Beforeinstallingyourlightttingalways
switchoffthemainssupplyandremovetheappropriatefuseorswitchofftheappropriatecircuitbreaker
beforecommencinginstallation,andensurethatnooneelsehasaccessthatwouldenablethesupplyto
beinadvertentlyreconnected.
• Nevertbulbsofahigherwattageorofatypeotherthanthosespeciedonthelabelasthismaycause
overheatinganddamagethetting.
• Theseproductcontainsglassparts–becarefulduringhandlingandmaintenancetoavoidbreakage.
• Ifanymodicationismadeitwillinvalidatethewarrantyandmayrendertheproductunsafe.
57509-Renner6lt-F20160429
EndonLighting,LS90SE
Assembly/ User Instructions
Before you start
Pleasereadtheseinstructionscarefullybeforettingandretainforreference.Checkthepackagingandmake
surethatyouhavealltherequiredparts.Followeachassemblystepinordertopreventincorrectassembly.
Ensurethattheproductisfullyassembledasillustratedbeforeuse.
This type of Light Fitting may be connected to a Dimmer if a Tungsten incandescent bulb is used. If a
CFL/LED type bulb is tted then these cannot (generally) be controlled by a dimmer.
The Light pack contains:
Lighttting.
Terminalconnectionblock(s).
Fixingpack.
Glassplate.
Decorativedrops.
The following tools may be required:
Selectionofcrossandatheadscrewdrivers.
Electricdrillandassorteddrillbits.
Wirestrippers.
Electricalinsulationtape.
These assembly diagrams are intended as a guide – if in doubt consult a qualied electrician.
Care Information
Allow10minutestocoolbeforereplacing,adjustingorcleaning.
Cleanwithadryclothonly.Donotuseliquidorabrasivecleanersonthisproduct.
1. Decideonthepositionofthelighttting,orremoveexistinglighttting.Takeanoteofthepositionofthe
electricalconnections.Ensurethereisasolidmountingsurface,preferablyawoodenjoistorjoistbridgeto
supporttheweightofthelighttting.
2. Removethexingbracketbyundoingthe2sidescrews(3),retainforre-use.
3. Usethexingbracketasatemplatetomarkthescrewholes,markthescrewholesandsecuretotheceiling
withthexings(1)supplied.
4. Slidetheglassplate(4)overthebodyofthettingsoitrestsonthelip,andsecureinplacewiththemetal
tabandscrew(5)

EndonLighting,LS90SE
5. Support your tting and connect the house wiring to the terminal block (2) – see wiring details. NOTE:
This is a Class I tting and must be earthed. The 4th terminal block connector is used for the “loop”
wiresofthe“RingCircuit”.Theremaybemorethanonesetofcablesinthe“loop”connections. If there is
a “Ring Circuit” and you do not understand the connections you must consult an electrician. Any
looseterminalblocks–notsecuredtoceilingcup-shouldalwaysbecoveredwith2layersofgoodquality
insulationtape.
6. Securethettingbackontothexingbracketwiththe2sidescrews(3),removedin2above.Makesurethat
alltheinternalcablesandconnectionsareinsidetheceilingcuptakingcarenottotraporstraintheinternal
cables.
7. Fitthedecorativedropassemblies(6-8)asshown.
8. Fitthebulbs(9)intothelampholdersbeingcarefulnottotouchthebulbswithyourbarehands–useacloth
orglovestoinsertthebulbs.NOTE: Never t bulbs of a higher wattage or of a type other than those
specied on the label (as these may cause overheating and damage the tting).
9. Turnonthepowerandtest.
Assembly/ User Instructions Continued
57509-Renner6lt-F20160429
X1pcs
4
X20pcs
X15pcs
X10pcs
X5pcs