BROSA Caelum Floor Lamp User manual

ASSEMBLY GUIDE
Caelum Floor Lamp
v1.0

Components
Before you get started, check you have all of the pieces below. If anything’s
missing, please visit www.brosa.com.au/pages/product-return-and-parts-request
and we’ll sort it out right away.
What you need
Hardware
A x 2 (Bolt) B x 1 (Allen key) C x 1 (Plastic Washer) F x 1 (Spanner)
D x 1 (Washer) E x 1 (Nut)
Top
Pole x 1
Bottom
Pole x 1
Base x 1 Base weight x 1
1
2
3
4
Shade screw x 1
Shade x 1
6
5

Safety
1. For indoor use only
2. Follow instructions carefully. Any deviations may be hazardous, or void
your warranty.
3. Damaged power cords must be replaced by a professional.
4. Never use a bulb of a greater wattage than recommended.
5. To replace the bulb, unplug the lamp from its power source and allow it to
6. Periodically check and re-tighten all screws and fasteners.
8. Firmly secure all pieces. Small parts may present a choking hazard.
9. Bulb is not included.
MAX 60W E27
220-240v ~ 50Hz

Step 1 Step 1.1 Align two poles (1)(2) so that the bolt holes are
overlapping. Secure the joint using a bolt (A) and the
allen key (B).
Step 1.2 Attach the formed part to the base parts
(5)(6). Fit a plastic washer (C), a washer (D) then a hex
nut (E) to the bolt and tighten with the spanner (F).
Step 1.1
Step 1.2
A
B
3
1
2
4
C
D
EF
A x 2
B x 1
C x 1
D x 1
E x 1
F x 1

Step 2
6
5
Place the shade (5) at the end of the socket. Carefully
adjust the shade and tighten it in place with the
shade screw (6). Gently screw the correct bulb (not
included) into the bulb socket.

Step 3 Check if all parts are secure.
Enjoy! We hope your new lamp lights up your life.