EQUATION IG-CBWW User manual

Glasswool and mineral fibre products
are NOT supported.
Installation Guide
EQ Corner Bracket Wall:Wall
Doc Code:
IG-CBWW
Supported Products
Page 1 of 2
All contents (c) 2018
www.eqacoustics.com
Spectrum 2.0 Tiles and Bass Traps
with Flexi Backing, including:
4 x Hook Strip 58cm
NOTE: We cannot guarantee the supplied fixings
are suitable for all walls. We recommend you
consult a professional before you proceed.
8 x Wall Mount
Wall mounting only, not suitable for
ceilings.
L5 Tile
L10 Tile
L10 Bass Trap
L10C Corner Bass Trap
32 x Small Self Drilling
Screws
4 x Cross Bar -
52cm
Fixing wall mounts for 45° position. (For alternative angles adjust measurements accordingly)
Locate where you wish to mount the panel and measure down 17.5 cm from the top edge and mark a
horizontal line (n) on the wall.
To locate the hole centres for the Wall Mount Screws, measure out from the corner in line with (n)
using the listed measurements for your particular product.
L10 Tile and L10 Bass Trap
(a) = 38.5 cm
L10C Corner Trap
(a) = 25.2 cm
Measure down 80 cm and
use the same measurements
to locate the hole centres for
the lower wall mounts.
When fitting wall mounts ensure
the pilot holes are furthest from
the corner.
Fix hook strips to outside face of Cross Bar as shown.
Fold ends of hook strip round for stronger adhesion
Apply pressure to activate adhesive.
We recommend allowing 48 hours for glue to cure before
hanging mount
L10C Corner Bass Trap Only
Cut Cross Bars down to 32.5cm
1
2
3
16 x Wall Plug
16 x Wall Screw
(n)
Version 1.0
Package Contents
4 No. Assemblies,
Supports 2 Panels.
For Larger or custom panels you may need to increase the number of fixings
(a)
(a)

EQ Corner Bracket Wall:Wall
Doc Code:
IG-CBWW
Page 2 of 2
All contents (c) 2018
www.eqacoustics.com
Push the Panel firmly onto the brackets
4
5
Attach the Cross bars to the Wall Mounts as shown
For horizontal mounting of tiles and traps where the wall meets the ceiling,
use our "Corner Bracket Wall:Ceiling" system.