EVERCROSS HB24 User manual
Take out the scooter from the
package. Hold the handlebar on
the ground to unfold the scooter.
After hearing a "clang" sound,
insert the safety latch into the
corresponding hole.
After the scooter is unfolded,
release the kickstand. (The
kickstand is on the left side of
the rear wheel of the motor.)
3. Remove the packing sponge from the handlebars, and then lift it up from
bottom to top. When the two handlebars are kept at the same level, the spring
loops of the handlebars will be locked and fixed automatically.
4. After adjusting the dashboard to a proper angle, use the S4 hexagonal screw
wrench in the tool kit to tighten the fixed screw on the back.
S4
5. After adjusting the horn and headlight switch to a proper angle, use the S3
hexagonal screw wrench in the tool kit to tighten the fixed screw on the back.
6. Remove the packing sponge from the seat, keep it 90° perpendicular to the
scooter, and fix the seat with the quick-release buckle on the seat base.
S3
7. Cut off the PE bag and tie that bind the headlights, use the S5 hexagonal screw
wrench in the tool kit to unscrew the fixed screw on the front suspension, then put
the headlight bracket in this position and re-tighten the screw to fix the headlight.
8. Take out the seat from the package, insert it into the aluminum tube of the seat
bottom, adjust the height and fasten it in place so that the seat is parallel to the scooter.
S5
9. After adjusting to the proper
height, fasten the quick-release
buckle to keep the height.
10. Insert the key into the keyhole
of the dashboard, turn the key
clockwise and then long press the
dashboard switch, the scooter and
dashboard will light up normally.
11. After starting up, short press
the M button to switch the speed
gear, 1/2/3 gear
12. After starting up, long press
the M button to turn on/off the
LED lights on both sides.
13. After starting up, press the horn and headlight switch ON/OFF button to turn
on/off the headlights and taillights.
14. After starting up, toggle the button in the middle of the horn and headlight
switch to turn on/off the left and right turn signals.
HORN
15. After starting up, press the red
button under the horn and headlight
switch, the horn warning sound will
be sounded simultaneously.
16. After starting up, toggle the
acceleration dial on the dashboard,
the scooter will accelerate forward.
17. When the scooter is not in use, long press the dashboard switch button firstly,
and then turn off the key, so that you can keep the current mileage to the total
mileage of the dashboard.
We provide warranty service and lifetime after-sales consulting service for
our electric scooters.
Please contact our Amazon Customer Service Team to help if you have
any problems, we'll reply you at the earliest and provide satisfied solutions
for you as soon as possible.
Email:[email protected]
Website: https://www.evercross.eu/
MAINTENANCE CONTACT INFORMATION：
Other EVERCROSS Scooter manuals
