EZ-CLONE MAG450 User manual

EZ-CLONE
OWNER’S MANUAL
SUBMERSIBLE PUMP
Model: MAG450, MAG750 , MAG925, MAG1125
INTRODUCTION
EZ-CLONE pumps are carefully inspected and tested to ensure
both safety and operating performance. However, failure to
follow the instructions and warnings in this manual may result
in pump damage and/or serious injury. Be sure to read and save
this manual for future reference.
LIMITED LIFETIME REPLACEMENT WARRANTY
EZ-CLONE Enterprises Incorporated (“EZ-CLONE”) warrants only to the
original purchaser of this product from an EZ-CLONE authorized retailer
or distributor that this product will be free from defects in material and
workmanship under normal use and service for the lifetime of the purchase.
EZ-CLONE reserves the right, before having any obligation under this limited
warranty,toinspectthedamagedEZ-CLONEproductandallcostsofshippingthe
EZ-CLONE product to EZ-CLONE for inspection shall be borne solely by the
purchaser. In order to recover under this limited warranty, purchaser must
make claim to EZ-CLONE within 30 days of occurrence, and must present
acceptable proof of original ownership (such as original receipt, warranty
card registration, online registration, or other documentation EZ-CLONE
deems acceptable) for the product. EZ-CLONE, at its option, shall repair or
replace the defective unit covered by this warranty. Please retain the dated
sales receipt as evidence of the original purchaser’s date of purchase. You
will need it for any warranty service. In order to keep this limited warranty
in effect, the product must have been handled and used as prescribed in
the instructions accompanying this warranty. This limited warranty does not
cover any damage due to accident, misuse, abuse or negligence. This limited
warranty is valid only if the product is used with the equipment specified
on the product box. This limited warranty is non-transferable and does not
apply to any purchaser who bought the product from a retailer or distributor not
authorized by EZ-CLONE, including but not limited to purchases from internet
auction sites. This warranty does not effect any other legal rights you may
have by operation of law. Contact EZ-CLONE at www.ezclone.com/contact/.
For questions and replacement parts please
contact us: www.EZCLONE.com
916.626.3000 | 866.EZ-CLONE | [email protected]

WARNING
• Risk of electric shock - This pump is supplied with a grounding
conductor and grounding type attachment plug. To reduce
risk of electric shock, be certain that it is connected only to
properly grounded, grounding-type receptacle.
• Risk of Electric Shock, Do not remove cord and strain relief.
Do not connect conduit to pump.
• This Pump Has Been Evaluated for Use With Water Only
• Reduce risk of electric shock during operation of this pump
requires the provision of acceptable grounding.
• Risk of electric shock – This pump has not been investigated
for use in swimming pool or marine areas
• Do not connect to any voltage other than that shown on the
pump.
• Always disconnect from electrical outlet before handling the
pump.
• Don’t operate without water.
• Operate pump completely submerged for proper cooling.
PERFORMANCE
A clogged or dirty intake screen will greatly reduce performance.
If the pump is used on a dirty surface, raise it slightly to reduce
the amount of debris contacting the intake. If less flow is desired,
adjust the flow control lever on the side of the pump or restrict the
discharge flow.
Do not let the pump run when not submerged in water. Doing so
may damage the pump. Always submerge the pump first, and then
plug in the electrical outlet. The pump is to be supplied through a
residual current device (RCD) with a rated residual operating cur-
rent not exceeding 30 mA.
MAINTENANCE
To clean the pump, remove the back cover and the impeller.
Use a small brush or stream of water to remove any debris
CAUTON: The pump shaft can not be removed.
IF THE PUMP FAILS TO OPERATE, CHECK THE FOLLOWING:
• Check the circuit breaker and try another outlet to ensure the
pump is getting electrical power. NOTE: Always disconnect
from electrical outlet before handling the pump.
• Check the pump discharge and tubing for any obstructions.
Algae build up can be flushed out with a garden hose.
• Check the inlet to ensure it is not clogged with debris.
• Remove the pump inlet to access the impeller area. Turn the
rotor to ensure it is not broken or jammed.
• Monthly maintenance will add to your pump’s life. NOTE:
• Ensure that the electrical cord loops below the electrical out-
let to form a “Drip Loop” This will prevent water from running
down the cord into the electrical outlet.