ferm living OYSTER User manual

OYSTER TABLE LAMP
ASSEMBLY MANUAL

GENERAL INSTRUCTIONS
WARNING:
The safety of this fitting can only be guaranteed if the following instructions are observed during both
installation and use. Please retain these instructions safely after installation.
PLEASE OBSERVE THE FOLLOWING GUIDELINES:
- Ensure that the power supply has been switched o prior to installation or removal of the product.
- Never undertake an electrical installation without the proper know ledge or training. If not familiar with
electrical wiring, contact a qualified electrician.
- The product may in no way be modified or tampered with. Any modification may compromise safety and
make the product itself dangerous to use. FERM LIVING does not accept any responsibility for products that
have been modified.
- All electrical components of the Oyster Wall Lamp can be replaced.
- The LED strip and the driver must be replaced in pairs to be sure that they work properly.
- Any modification must be performed only by qualified personnel to avoid any danger.
- This product is meant for indoor use only.
- This appliance should not be disposed in a domestic trash receptacle and should instead be recycled appropriately.
CLEANING INSTRUCTIONS:
- Use only a soft cloth to clean the product. Dampen the cloth with water and soap or a mild cleanser if needed.
MORE INFORMATION:
To access further information such as product overview and material descriptions, please visit our website
at www.fermliving.com. If you have any questions or comments, please do not hesitate to contact us
at info@ fermliving.com .
PLEASE READ BEFORE INSTALLATION

x1
Lamp
x1
Opal Dimmable
E14 bulb
Voltage: 220-240V – 50Hz
Dimmable: Yes
Certification: CE, IP20
Recommended Light source: Dimmable LED Opal light bulb, E14, 4W
OYSTER TABLE LAMP
BOX CONTENT
TECHNICAL SPECIFICATIONS

Mount the bulb
in the E14 socket
ASSEMPLY PROCESS
1

Turn the lamp on and off
with the button on the back
ASSEMPLY PROCESS
2

fermliving.com