FETtec OSD Board User manual

FETtec OSD Board
Manual
Page 1

Table of Contents
Introduction.....................................................................................................................................3
Features..........................................................................................................................................3
Connection Diagram.......................................................................................................................4
Layout.........................................................................................................................................4
Dimension (in mm).....................................................................................................................4
Basic Setu .....................................................................................................................................5
6 Pin connection (cable included)..............................................................................................5
VTX connection..........................................................................................................................6
Camera connection....................................................................................................................6
OSD Firmware ...............................................................................................................................7
Settings...........................................................................................................................................7
Issues in the icture...................................................................................................................9
Move elements in the OSD menu..............................................................................................9
Page 2

Introduction
Thank you for urchasing the KISS com atible FETtec OSD Board.
Features
•Gra hic OSD (STM32)
•Full KISS Tuning
•Filter (PIDs, Rates, Settings)
•LED control (RGB LED, Racewire)
•VTX
•Live data gra hs (Voltage, motor r m, current, motor tem , gyro values, link
quality)
•KISS GPS su ort + live ma
•Custom gra hic ilot logo
•Stick overlay
•Custom layout
Connection via Solder ads or JST 6 in lug (FETtec FC and KISS FC com atible) + video
connection
•KISS FC com atible
The FETtec OSD works with KISS/FETtec FC firmware version .3RC45Y or later !
Page 3

Connection Diagram
Layout
GND – Reference Signal Ground
5V from FC
Vin + Vout – Video in and out
n c – not connected
JST-SH-1mm 6- in connection
Dimension (in mm)
Page 4
n c

Basic Setup
6 Pin connection (cable included)
(JST-SH-1mm 6- in)
This can be connected via straight 6 in ada ter to any FETtec FC / KISS FC serial ort
OSD only works with connected camera!
FETtec OSD Board to FETtec KISS FC
Page 5
GND
VTX 5V
BAT+
RGB LED
TX
RX

VTX connection
Camera connection
Page 6
GND Video out
GND
Cam Video out5V

OSD Firmware
Please update the FETtec OSD Board before your first flight !
To u date the FETtec OSD connect to FETtec Configurator and flash via FC assthrough latest
firmware.
Settings
All settings are to set directly in the OSD
To get in the menu move the sticks in the shown direction at the start:
Throttle 50%, then move Yaw left, Pitch u
Mode 1:
Mode 2:
Page 7

In the menu:
OSD settings:
Page 8

Issues in the picture
1. OSD SYNC → AUTO SYNC
2. in case of unshar lines lay with LEFT/WITH values try to avoid WITH values above 400
3. make a PAL/NTSC layout reset
Move elements in the OSD menu
Choose LAYOUT → SET POSITIONS in the SETTINGS.
Now the elements are movable along the grid.
Ski between the elements and select them to set new osition.
To exit the ´move menu´ hold stick Yaw left for a few seconds
Page 9