FibreHead FH-TRI User manual

Hardware
Included
Tools Required
Modern Shelf bracket set
FH-TRI
Thank you for purchasing our modern triangular shelf brackets.
These brackets are designed for 8” deep real wood shelves, 5/8” or thicker.
Please read these instructions from start to finish before beginning.
For any issues or questions contact [e-mail]
-Always check/detect routing of pipes and electrical before penetrating/drilling walls.
Tape Measure Drill and Philips bit +
6mm or 1 /4” Drill bit
Stud Finder
(8x) 5/8” Wood Screw
For wood Shelf (8x) 1” Wood Screw
For drywall anchors
(8x) Drywall
Anchors
Parts
Included
Safety Glasses
45degree Cut Shelf
Pencil
Any Issues or questions contact [e-mail]
(4x) 2.5” Wood Screw
For wall studs
Level
Straight Cut Shelf
Decide on which configuration you prefer.
Shelf length should not exceed 5’ or 60”
without additional brackets.
Or

Drill
Stud Finder
Installation
Safety Glasses
Step 1. Locate and Mark Studs (At least one bracket should be installed into a Stud)
Measure
to match
Height
Step 2. Mark hole locations with bracket as template ,Drill Drywall anchor locations
1 /4” or 6mm
Drill bit
1. Place the bracket over stud mark and level.
2. Use the bracket as a template to mark holes. Draw Stud +drywall o
3. Remove bracket and drill holes for drywall anchor locations o
(studs +don’t use drywall anchors/ don’t drill)
4. Insert drywall anchors into holes, tap in if needed. Repeat other side.
Step 3. Fasten brackets, mark and
cut shelf. Fasten shelf. 1.Place brackets onto holes.
Insert 1” screws into drywall anchors
Insert 2.5” Screws into stud locations.
2.Place 8” Shelf on brackets and mark lines for cuts. Cut
shelf to length desired.
-Most hardware stores will do cuts if requested-
Sand and finish shelf as desired.
3. Fasten shelf with 5/8” screws (x8) , Finished.
Stud
Any Issues or questions contact [e-mail]
Pencil
Most common shelf height
is 4.5 feet or 54” from floor.
Studs are spaced 16” apart.
Level
Drill and Philips bit +
Pencil
Pencil