FirsTime 81007 User manual

"44&.#-:*/4536$5*0/4

HANGING INSTRUCTIONS
* *
Designed for fastening in drywall and hollow block. Manufacturer shall not be liable for any fastening failure due
to improper installation or defective substrate material.
Drill
Insert
Read these instructions carefully. Failure to follow
these instructions can result in serious personal injury.
Fig A. Hooks facing towards door
4 Screws for Door Hangers
DOOR HANGING HARDWARE
place screw through
drill hole and tighten
into anchor
Insert
Wall hanging instructions:
1. Place 1 EVA foam dot on each back corner of the cabinet
2. Determine your desired hanging location of the cabinet and mark
where screws should go
3. Place wall anchors into the wall at marked spots; make sure anchors
are level.
Drill hole at least 1/4” deeper than the anchor. (Requires 3/16 Drill bit)
4. Do not exceed 35 lbs in over all weight.
5. Enjoy your new Cabinet!
Fasten Screws through the back panel , from the interior of the cabinet
and into the wall anchors In the wall.
Fasten
Over the door hanging instructions:
1. Determine your preferred height for hanging and position hooks to
align with the corresponding hole
2. Before screwing the hooks onto the back of the cabinet make sure
that the top of the hook is facing towards the door. (Fig A)
3. Screw in all 4 screws tightly to secure the hangers to the back of the cabinet
4. Place EVA foam dot on each of the 4 screw on the back of the cabinet
5. Hang the cabinet over your chosen door
6. Determine desired location for Velcro strips
7. Place one side of the Velcro strip to the back of the cabinet and the
other side to the door to minimize movement of the cabinet on the door
8. Enjoy your new Cabinet!
2 Wall Anchors & Screws
WALL HARDWARE
.
.