FORM & REFINE POSITION BENCH 155 User manual

POSITION BENCH 155
Assembly guide
STEP 1
Place the seat bottom up on any larger table.
To protect the surface from scratches lay a
piece of textile or cardboard under the seat.
STEP 2
Place the leg frames above the bushings.
Using the included hex key, mount the screws
in the seat. Tighten the screws properly,
though without fully tightening them.
STEP 3
Place the two brass parts on the seat and
mount the short brass screws. Tighten
the screws with a flat-head screwdriver.
Important note: Brass is softer than iron,
therefore be careful not to scratch the screw.
formandrefine.com

POSITION BENCH 155
Assembly guide
STEP 5
Place the backrest in the two dowels. Mount
the two long brass screws in the backrest.
Important note: Brass is softer than iron,
therefore be careful not to scratch the screw.
STEP 6
Good work, you are now done. The screws
might have to be tightened after a while when
the bench has been in use. Therefore, keep
the tools for later use.
STEP 4
Place the two dowels in the legs.
formandrefine.com