Forms + Surfaces SUMMIT BIKE RACK User manual

SUMMITTM BIKE RACK
SURFACE MOUNT INSTALLATION INSTRUCTIONS
page 1 of 3 | Rev. 05-19-14
© 2014 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
TOOLS NEEDED
MATERIALS INCLUDED
STEP BY STEP
Mark hole locations
• Place bike rack in desired location. Mark
center of each hole location with a
pencil.
Drill holes
• Use hammer drill to drill 4.5" deep x 3/4"
diameter anchor hole at each marked
location using a 3/4" drill bit suitable for
concrete drilling.
NOTE: Forms+Surfaces recommends
starting holes with 1/4" diameter drill
bit followed by 1/2" and nally 3/4" for
maximum accuracy.
Fill holes & insert anchors
• Use compressed air and steel wire brush
to clean each anchor hole in accordance
with epoxy instructions.
• Use epoxy in epoxy gun to ll each anchor
hole 5/8 of the hole depth in accordance
with epoxy instructions.
• Insert 3/8"-16 x 4-1/4" epoxy anchor
(a) into each anchor hole so anchor top
is ush with ground. Allow proper curing
time according to cure schedule on epoxy
instructions before moving on to Step 4.
epoxy gun
steel
wire brush
hammer drill
pencil
a b
epoxy
7/32"hex bit for
tamper-resistant
screws
FOR ALL SURFACE MOUNTED SUMMIT BIKE RACKS
c1/4", 1/2"& 3/4"drill
bits for concrete Loctite
a

SUMMITTM BIKE RACK
SURFACE MOUNT INSTALLATION INSTRUCTIONS
page 2 of 3 | Rev. 05-19-14
© 2014 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
Position bike rack
• Position bike rack so that mounting
holes line up with anchors.
Attach bike rack
• Insert four 3/8"-16 x 1-1/4" hex head
cap screws (b) into mounting holes in
bike rack.
Attach base plate & tighten screws
• Slide base plate over bike rack.
• Thread two 3/8"-16 x 1" pin-in-hex
button at head screws (c) through each
hole using 7/32" hex bit for tamper-
resistant screws.
• Tighten all screws.
NOTE: Forms+Surfaces recommends
applying Loctite® or similar thread-
locking adhesive.
STEP BY STEP FOR ALL SURFACE MOUNTED SUMMIT BIKE RACKS
c
b

SUMMITTM BIKE RACK
SURFACE MOUNT INSTALLATION INSTRUCTIONS
page 3 of 3 | Rev. 05-19-14
© 2014 Forms+Surfaces® | All dimensions are nominal. Specifications and pricing subject to change without notice. For the most current version of this document, please refer to our website at www.forms-surfaces.com.
T 800.451.0410 | www.forms-surfaces.com
RECOMMENDED BICYCLE RACK SPACING PER ASSOCIATION OF PEDESTRIAN AND BICYCLE PROFESSIONALS (APBP) GUIDELINES FOR ALL SUMMIT BIKE RACKS
96" (72" min) 60" (48" min) 96" (72" min)
36" min
36"
(24" min)
36" min
48" min
wall
wall
wall
SUMMIT BIKE RACK
wall