Crestron CNWM-LT9 User manual

CRESTRON CNWMBG-10A Wall-Mount Wired Panels
REMOTE CONTROL SYSTEMS
1 DOC. 8078
Specifications subject to change without notice.
DESCRIPTION:
The CNWMBG-10A wired panel, illustrated in figure 1, interfaces with a CRESNET II control system over
theCRESNETIInetwork.Thepaneluses10miniaturepushbuttonswithself-containedfeedbackLEDsand
includes a standard bargraph. The CNWMBG-10A is designed for wall-mounting using a standard single-
gangelectricalbox.Custompanelfinishes,engraving,colored button caps, and theomissionof unused
buttons are all standard.
1
3
5
7
910
8
6
4
2
CRESTRON
Figure 1. CNWMBG-10A, Wall-Mount Wired Panel
INSTALLATION/SETUP:
Identity Code
Eachunique panel or component on the CRESNET II network requires thesettingof an identity code (ID
CODE). ID CODES are two-digit hexadecimal numbers, from 10 to FE.
TheID CODE of thepanelshould be set tomatch the ID CODE specifiedin the NET.ID statement ofthe
CRESNET II SIMPL-C program referencing the panel (refer to SYNTAX section). To set an ID CODE,
disconnect power. Accessible through the back cover are two miniature circuit-mounted rotary
switches, identified as H and L. These 16-position hexadecimal switches can be set to 0 through F. Using
a small screwdriver, rotate the arrow in the center of the switch marked H so that it points to the first
(or most-significant) digit or letter of the specified ID CODE. Set the switch marked L to the second
(least-significant) digit or letter of the specified ID CODE.

CRESTRON CNWMBG-10A Wall-Mount Wired Panels
REMOTE CONTROL SYSTEMS
2 DOC. 8078
Specifications subject to change without notice.
Preparation for Use
The 4-pin connector marked NET must be wired to the CRESNET II network. Network termination points
are available at the control system power supply. Network units may also be daisy-chained together.
Refer to the latest revision of CNPWS power supplies (Docs. 8017 and 8091) in the CRESNET II manual
forwire gauge specifications and connection detail.
PROGRAMMING:
Thepaneldrawinginfigure1showsthelocationoftheSIMPL-Cbuttonnumbersandtheircorresponding
buttonpositions. Buttons or bargraphs which arenotused need not be assignedasignal name.
SYNTAX:
Thefollowingsyntaxcodesareprovidedforcompatibilitypurposesonly.
NET.ID <10 to FE>: CNWP
i1,o1 = <signal name> \ button and LED combined
i2 = <signal name> \ independent button
o2 = <signal name> \ independent LED
" = " "
i10 = <signal name>
o10 = <signal name>
<BAR1> = <signal name> \ first bargraph level
FURTHER INQUIRIES:
If after reviewing this Operations Guide you still have additional questions, please contact a CRESTRON
technical support representative by dialing [phone] or [phone].