Fossil STARCK STRAP User manual

Strap Instructions
FIGURE A FIGURE B
Strap
Buckle
Tongue
1. To adjust length of strap, locate screws on
inside of buckle and remove. (fig. A)
2. Remove metal retainer from strap. (fig. B)
Note: Once strap is cut to length, the cut
piece cannot be reattached. Be sure the
proper length is determined before cutting.
3. Cut strap to desired length. Replace metal
retainer into seat. Slide buckle over metal
retainer and replace screws.
FIGURE B
Seat for
Metal
Retainer
Wall
Strap
Metal
Retainer
Buckle
Screws
FIGURE A
1. To adjust the length of strap, locate top
side of buckle. (fig. A)
2. Open buckle by taking out the pin inside in
either direction and remove strap. (fig. B)
Note: Once strap is cut to length, the cut
piece cannot be reattached. Be sure the
proper length is determined before cutting.
3. Cut strap to desired length. Slide strap
back into buckle, then close the buckle
by pressing the cover and insert the pin
again in either direction until hear a “click”
sound. (fig. B)
FIGURE A
Wall
Strap
Buckle
FIGURE B
Take out pin (in
either direction)
and open buckle.
1. To adjust the length of strap, locate tongue
on inside of buckle. (fig. A)
2. Open buckle and pull long end of strap
until tongue snaps open. (fig. B)
3. Pull strap to desired length and line tongue
up with hole. Snap shut to close and
secure strap.