Frigidaire FPMO3077T User manual

BUILT-IN CONVECTION MICROWAVE INSTALLATION INSTRUCTIONS
Important Notes to the Installer
1. Read all of the installation instructions before instal-
ling the microwave oven.
2. Remove all packing material from the oven compart-
ments before connecting the electrical supply to the
microwave oven.
3. Observe all governing codes and ordinances.
4. Be sure to leave these instructions with the consu-
mer.
5. The oven door may be removed to facilitate installa-
tion.
Important Notes to the Consumer
Keep these instructions with your Owner's Guide for the
local electrical inspector's use and future reference.
IMPORTANT SAFETY INSTRUCTIONS
• Be sure your microwave oven is installed and
grounded properly by a qualied installer or service
technician.
• This microwave oven must be electrically grounded
in accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No.
70- latest edtion in the United States, or with CSA
Standard C22.1, Canadian Electrical Code, Part 1, in
Canada.
Stepping, leaning, or sitting on the door
of this microwave oven can result in serious injuries and
can also cause damage to the microwave oven.
• Never use your microwave oven for warming or hea-
ting the room. Prolonged use of the microwave oven
without adequate ventilation can be dangerous.
The electrical power to the microwave
oven must be shut off while line connections are being
made. Failure to do so could result in serious injury or
death.
1. Carpentry
Refer to gure 2, 3, or 4 for the dimensions applicable to
your appliance and the space necessary to receive the
oven. The oven support surface may be solid plywood or
similar material, however, the surface must be level from
side to side and from front to rear.
2. Electrical Requirements
This appliance must be supplied with the proper voltage
and frequency, and it must be connected to an individual,
properly grounded branch circuit protected by a circuit-
breaker or fuse.
Electrical Requirements:
• A three-prong grounded outlet
• 120 V, 60 Hz, AC only
• 20 Amp electrical supply with a fuse or a circuit
breaker
• 20 Amp outlet duplex must be used
Figure 1: 3-prong 20-Amp Grounded Outlet
PN A06823502 Rev. A (17/08)
English – pages 1-5
Español – páginas 6-10
Français – pages 11-15
Printed in U.S.A.
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other ammable vapors
and liquids in the vicinity of this or any other appliance.
Your new microwave oven has been designed to t a limited variety of cutout sizes to make
the job of installing easier. The rst step of your installation should be to measure your current
cutout dimensions and compare them to the cutout dimensions chart below for your model.
You may nd little or no cabinet work being necessary.
United States
and Canada
1

BUILT-IN CONVECTION MICROWAVE INSTALLATION INSTRUCTIONS
All dimensions are in inches (cm).
PRODUCT DIMENSIONS
MODEL A B C D
Convection Microwave Oven 29-13/16 19 24-5/8 23
CUTOUT DIMENSIONS AND CABINET WIDTH
MODEL F G HI
Min. Max. Min Min. Max. Min.
Convection Microwave Oven 28 28-3/8 22 17-3/4 18 30-1/8
NOTES:
1. The base must be capable of supporting 155 pounds
(70 kg).
2. Allow at least 21" (53.3 cm) clearance in front of the
oven for door depth when it is open.
3. Dimension G (cutout depth) is critical to the proper
installation of the built-in oven. If the oven decorative
trim does not lie ush against the cabinet, or if noise
is heard on convection models, verify dimension G
to assure that it is the required depth.
Figure 2: Microwave Only
A
B
C
17-5/8"
D
H
36" min
required
distance
to oor
2"
min
I
G
F
24" min
2"
min
Outlet
Area
20 Amp
Circuit
Do not lift or manipulate the oven door handle
or the control panel.
Heavy Weight Hazard
• Use two or more people to move and install the
microwave oven.
• Failure to follow this instruction can result in injury
or damage to the unit.
3. Cabinet Installation
1. Unpack the microwave oven.
2. Find the two mounting screws included in the litera-
ture package.
3. Insert the oven into the cabinet opening.
4. Push the oven in and against the cabinet.
2

BUILT-IN CONVECTION MICROWAVE INSTALLATION INSTRUCTIONS
NOTES:
1. The base must be capable of supporting 155 pounds
(70 kg).
2. Allow at least 21" (53.3 cm) clearance in front of the
oven for door depth when it is open.
3. Dimension G (cutout depth) is critical to the proper
installation of the built-in oven. If the oven decorative
trim does not lie ush against the cabinet, or if noise
is heard on convection models, verify dimension G
to assure that it is the required depth.
B
A
D
17-5/8"
36" min
required
distance
to oor
24" min*
2"
min
F
G
I
H
C2"
min*
Outlet
Area
20 Amp
Circuit
* See wall oven
installation instructions
for cutout dimensions
PRODUCT DIMENSIONS
MODEL A B C D
Convection Microwave Oven 29-13/16 19 24-5/8 23
CUTOUT DIMENSIONS AND CABINET WIDTH
MODEL F G HI
Min. Max. Min Min. Max. Min.
Convection Microwave Oven 28 28-3/8 22 17-3/4 18 30-1/8
Figure 3: Microwave with Wall Oven
All dimensions are in inches (cm).
3

BUILT-IN CONVECTION MICROWAVE INSTALLATION INSTRUCTIONS
PRODUCT DIMENSIONS
MODEL A B C D
Convection Microwave Oven 29-13/16 19 24-5/8 23
CUTOUT DIMENSIONS AND CABINET WIDTH
MODEL F G H
Min. Max. Min Min. Max.
Convection Microwave Oven 28 28-3/8 22 17-3/4 18
NOTES:
1. The base must be capable of supporting 155 pounds
(70 kg).
2. Allow at least 21" (53.3 cm) clearance in front of the
oven for door depth when it is open.
3. Dimension G (cutout depth) is critical to the proper
installation of the built-in oven. If the oven decorative
trim does not lie ush against the cabinet, or if noise
is heard on convection models, verify dimension G
to assure that it is the required depth.
Figure 4: Microwave Under Counter Top
B
A
D
17-5/8"
C
H
G
F
Outlet
Area
20 Amp
Circuit
36"
3"
min
24" min
All dimensions are in inches (cm).
4