FUNKY MONKEY BARS Floating Flying Fox User manual

Fo
For Button Swing or Flying Fox Handle

2

3

4
Assemble the Joiner and Fin-D152 with Fin as shown below. The 3 x grub screws
are to be inserted only once the Joiner and Fin is inserted inside and between
the 2 x 2950 silver poles.
Grub screws to be inserted into Joiner
and Fin- D152 with Fin after piece has
been inserted into and between 2 x
2950mm silver poles
152-D with Fin
Join 2 x 2950 silver poles found in Box F06
(c/o steel fitting 152-D with Fin – found in Box Q39)
152-D with Fin

5

After adding new fittings, add
the two outside legs back onto
unit.
6
Replace 2 x outside legs with new fittings

Assemble together the top
supporting bracket for the 6m
Floating Flying Fox pole – Head
protection is recommended.
Assembly of Top Supporting Bracket
7
125-D
125-D
119-D
104L-D
173f-D
101-D
1600m
m
600mm
600mm
530mm
Top bar
is in situ

Two People - Using a step ladder, fully insert the assembled top supporting bracket.
Place the 600mm silver pole ends into the 119-D fitting and the 104L-D fitting. Ensure
you hear the clunk noise as the poles touch inside the fittings and fully tighten the
grub screws. Head protection is recommended.
119-D
104L-D
Installing the Top Supporting Bracket to existing Top Swing Frame Bar
Make sure the new fitting 119-D is in place as shown,
before installing the supporting bracket on to the existing
frame.
8

9
104L-D

Assembly and Install of the 6m Floating Flying Fox Braces
Fully insert 2 x 48dia x 600mm silver pole – brace parts, into each 104L-D on the outside Legs.
Ensure the pipes
make a clunk
sound.
Fully tighten
10