
• Cautionary statements should be read before
beginning assembly.
• ADULT SET-UP AND SUPERVISION REQUIRED.
• Use only with Ground Fault Circuit Interrupt
(GFCI) receptacle.
• This blower is for residential use only. It is
not intended to be used in commercial or
industrial settings.
• Never insert fingers, pencils or any other
object through the grill at ANY time.
• Do not operate blower with a damaged cord
or plug, after the appliance malfunctions
or has been dropped or damaged in any
manner.
• Do not operate in the presence of explosive
and/or flammable fumes.
• Never connect the blower to any solid - state
speed control device.
• To reduce the risk of electric shock, do not use
this blower with any solid-state speed control
device.
• Always unplug the blower before servicing.
• Outdoor use only.
WARNING: FAILURE TO FOLLOW THESE
WARNINGS WILL RESULT IN INJURIES OR DEATH!
WARNING: FOLLOW ANCHORING INSTRUCTIONS
User must read and follow anchoring instructions to
ensure the proper number of anchors used, soil conditions,
and stake installation.
WARNING: ELECTROCUTION HAZARD
DO NOT USE EXTENSION CORDS WITH THIS PRODUCT.
INSTRUCTIONS FOR BLOWER INSTALLATION
NOTE: Set up as close to power source as
possible. The product should be periodically
examined for potentially unsafe conditions such
as: damaged cord, plug, housing or parts,
and that in the event such damage is found,
the product should not be used until properly
repaired. Never leave the blower outside in the
rain or exposed to the elements when not in use.
When in use, do not place the cord across traffic
areas, water or damp areas. The blower should
be placed on a stable surface and anchored
per product instructions. The power cord of the
blower is equipped with a Ground Faulty Circuit
Interrupter (GFCI) plug.
1.) Make sure that the blower switch is in the “OFF”
position. Plug the blower into a 110-120V GFCI
outlet.
2.) If the GFCI has been tripped, press the “RESET”
button to restore power to the blower.
3.) Set the power switch of the blower to “ON” to
inflate. After use, turn the power to “OFF”.
4.) To disconnect, have an adult grip blower tightly
and pull the plug from the wall outlet.
INSTRUCTIONS FOR BLOWER CLEANING AND STORAGE
• Do not immerse the blower in water. Unplug the blower before cleaning.
• To clean: wipe with a damp cloth. The blower does not require any lubrication and has no user
serviceable parts.
• Do not attempt to service the blower.
• When not in use, store the blower indoors in a dry place. Store the blower upright on a stable
surface. Loosely coil the cord and place it beside the blower.
This blower is not a toy. Use under the direct supervision of a competent adult. Keep away from children.
READ AND SAVE THESE INSTRUCTIONS.
Safety Warnings: Electrical Blower
This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk
of electric shock by providing an escape wire for the electric circuit. This product is equipped with a cord
having a grounding wire with an appropriate grounding plug. This plug must be plugged into an outlet that
is properly installed and grounded in accordance with all local codes and ordinances. DANGER - Improper
installation of the grounding plug can result in a risk of electric shock. If repair or replacement of the cord
or plug is necessary, do not connect the grounding wire to either blade terminals. The wire with insulation
having an outer surface that is green, with or without yellow stripes, is the grounding wire. Check with
a qualified electrician or serviceman if the grounding instructions are not completely understood, or if in doubt as to whether the product is properly
grounded. Do not modify the plug provided; if it will not fit the outlet, have the proper outlet installed by a qualified electrician. For a grounded, cord-
connected product, rated less than 15 amperes and intended for use on a nominal 110-120-volt supply circuit, these instructions should be followed. This
product is for use on a nominal 110-120-volt supply circuit, and has a grounding plug that looks like the plug illustrated in sketch A. Temporary adapters
should not be used. Do not use product until a properly grounded outlet (sketch A) can be installed by a qualified electrician.
CAUTION: USE ONLY ON GFCI PROTECTED RECEPTACLES
GROUNDING INSTRUCTIONS FOR ALL GROUNDED, CORD-CONNECTED PRODUCTS
4