
•
Cautionary statements which should be read before
beginning assembly.
•
ADULT SET-UP AND SUPERVISION REQUIRED.
•
Use only with Ground Fault Circuit Interrupt (GFCI)
receptacle.
•
This blower is for residential use only. It is not intended to
be used in commercial or industrial settings.
•
Never insert ngers, pencils or any other object through
the grill at ANY time.
•
Do not operate blower with a damaged cord or plug,
after the appliance malfunctions or has been dropped or
damaged in any manner.
•
Do not operate in the presence of explosive and/or
flammable fumes.
•
Never connect the blower to any solid - state speed
control device.
•
To reduce the risk of re or electric shock, do not use this
blower with any solid-state speed control device.
•
Always unplug the blower before servicing.
•
Outdoor use only.
WARNING: FAILURE TO FOLLOW THESE
WARNINGS WILL RESULT IN INJURIES OR
DEATH!
WARNING:
FOLLOW ANCHORING INSTRUCTIONS
User must read and follow anchoring instructions
to ensure the proper number of anchors used, soil
conditions, and stake installation.
WARNING:
ELECTROCUTION HAZARD
DO NOT USE EXTENSION CORDS WITH THIS PRODUCT.
INSTRUCTIONS FOR BLOWER INSTALLATION
NOTE: Set up as close to power source as possible. The
product should be periodically examined for potentially
unsafe conditions such as: damaged cord, plug,
housing or parts, and that in the event such damage
is found, the product should not be used until properly
repaired. Never leave the blower outside in the rain or
exposed to the elements when not in use. When in use,
do not place the cord across trac areas, water or damp
areas. The blower should be placed on a stable surface
and anchored per product instructions. The power cord
of the blower is equipped with a Ground Faulty Circuit
Interrupter (GFCI) plug.
1) Make sure that the blower switch is in the “OFF”
position. Plug
the blower into a 110-120V GFCI outlet.
2) If the GFCI has been tripped, press the “RESET” button
to restore
power to the blower.
3) Set the power switch of the blower to “ON” to inate.
After use,
turn the power to “OFF”.
4) To disconnect, have an adult grip it tightly and pull
the plug from the wall outlet.
INSTRUCTIONS FOR BLOWER CLEANING
AND STORAGE
Do not immerse the blower in water. Unplug the blower
before cleaning.
To clean: wipe with a damp cloth. The blower does not
require any lubrication and has no user serviceable
parts.
Do not attempt to service the blower.
When not in use, store the blower indoors in a dry place.
Store the blower upright on a stable surface. Loosely coil
the cord and place it beside the blower.
CAUTION: USE ONLY ON GFCI PROTECTED RECEPTACLES
GROUNDING INSTRUCTIONS FOR ALL GROUNDED, CORD-CONNECTED PRODUCTS
This blower is not a toy. Use under the direct supervision of a competent adult. Keep away from children.
READ AND SAVE THESE INSTRUCTIONS.
Safety Warnings: Electrical Blower
This product should be grounded. In the event of an electrical short circuit, grounding reduces
the risk of electric shock by providing an escape wire for the electric circuit. This product is
equipped with a cord having a grounding wire with an appropriate grounding plug. This plug
must be plugged into an outlet that is properly installed and grounded in accordance with all
local codes and ordinances. DANGER - Improper installation of the grounding plug can result in a
risk of electric shock. If repair or replacement of the cord or plug is necessary, do not connect the
grounding wire to either at blade terminal. The wire with insulation having an outer surface that is
green, with or without yellow stripes, is the grounding wire. Check with a qualied electrician or serviceman if the grounding instructions are
not completely understood, or if in doubt as to whether the product is properly grounded. Do not modify the plug provided; if it will not t the
outlet, have the proper outlet installed by a qualied electrician. For a grounded, cord-connected product, rated less than 15 amperes and
intended for use on a nominal 110-120-volt supply circuit, these instructions should be followed. This product is for use on a nominal 110-
120-volt supply circuit, and has a grounding plug that looks like the plug illustrated in sketch A. Temporary adapters should not be used. Do
not use product until a properly grounded outlet (sketch A) can be installed by a qualied electrician.
4