GARAGEFLEX FX7004 User manual

If you have any questions or need some advice, please do call us on 01491 579975 or email us at
[email protected] and we will do our best to help.
FX7004 Overhead Storage Rack
Assembly Instructions
Package Contents:
1 x Overhead Storage Rack 1.2x1.2m
Tools Required:
Phillips screwdriver
Pliers
Drill
Tape Measure & Pencil
Stud finder
Safety glasses
Ladder
Hacksaw or Grinder with cutting disc

If you have any questions or need some advice, please do call us on 01491 579975 or email us at
[email protected] and we will do our best to help.
Notes:
1. This Rack is designed for installation into ceiling wood joists or floor joists. Do not install
into metal or concrete ceilings.
2. The installation brackets can be installed directly onto the joists or through drywall into
the joists. If installing through drywall, you will have to identity the joist centres with a
stud finder
3. Plan your installation carefully
4. The standard drop distance from the ceiling is 1metre.
5. There are two other pre-determined drop distances of 0.5m and 0.75m. The hanging
tubes are predrilled for these distances but will have to be cut to fit

If you have any questions or need some advice, please do call us on 01491 579975 or email us at
[email protected] and we will do our best to help.
Step 1: If installing through drywall, locate and mark the ceiling joists using either a stud
finder or drill
Step 2: Use a joist bracket (Item N) and mark the bracket centrelines and hole locations. Pre
drill 3/16”holes in the joists and install the brackets using the 3”lag bolts (Item H).
Step 3: Determine the desired shelf level and cut the hanger tubes (Item B) to length if
required.

If you have any questions or need some advice, please do call us on 01491 579975 or email us at
[email protected] and we will do our best to help.
Step 4: Connect the joist brackets and hanger rods using screws and nuts (items F and I)
Step 5: Connect the support channel (Item C) to the hanger rods using screws and nuts
(Items F and J)
Step 6: Lay the wire shelves (Item A) on the support channels and fasten to the support using
clips and screws (Items E and G). Snap the accent strips (item D) into the support channels.
Step 7: Connect the two shelves together using screws, nuts and washers (items K, L and M).

If you have any questions or need some advice, please do call us on 01491 579975 or email us at
[email protected] and we will do our best to help.
Installation using Garageflex PowerTrack
You will need a set of FX9154 Round Ceiling Connectors which are supplied separately.
Step 1: Mark the ceiling joist locations where you want to install the rack
Step 2: Install two pieces of PowerTrack at 128.59cm apart and install the Track at 90 degrees
to ceiling joists
Step 3: Install the 4 round ceiling connectors at 610mm to 914mm apart on the PowerTrack
Step 4: Complete installation using the instructions above