Garden Gear G4792 User manual

G4792 6 x 6 Foot PE Cover Shed Instruction Manual
For correct usage, please read these instructions carefully before use and keep in a
safe place for future reference.
General Information and Safety Warnings
•Remove all packaging and make sure that the product is intact. Do not leave
packaging materials like bags and staples within the reach of children and
pets.
•Only use the product for its intended purpose.
•The manufacturer is not responsible for any eventual damages caused by
improper or faulty use.
•Do not use any open flames inside or near the shelter.
•Always check for overhead electric wires, tree branches or other structures
before installing the shed. Be aware of anything that could cause rainwater to
run off onto the shed.
•Do not store any flammable liquids inside the shed.
•Do not hang anything from the roof or supporting frame.
•Always take the cover off and store away safely if severe weather is forecast.
•Make sure that your shed is securely anchored to the ground, you are
responsible for the shed and ensuring it doesn’t become unanchored.
Periodically check the anchoring is still sufficient.
•The shed is not designed to be a permanent structure.
•Remove any gathered snow or rainwater immediately from the cover, this will
help prolong the life of your shed.
•Never used hard-edged tools (such as a shovel) to remove something from
the fabric of the shed.
•Not suitable for commercial purposes.
•At least two people are required to build this item and two sets of steps are
necessary.
•Until the bracing pieces and purlins are fitted, make sure that the upper
section of the arches are held firmly together so that they do not detach.

Care and maintenance
•Always make sure that the cover remains tight over the frame.
•Remove any gathered snow or rainwater from the roof with a soft-bristled
instrument (such as a mop).
•Spot clean with a soft, damp cloth as needed.
•Do not use bleach or any harsh abrasive products to clean the fabric.
•Remove the cover and store away if severe weather is forecast.

Parts List

Assembly
•Remove all parts from box and dispose of all packaging correctly.
•Check that you have all the parts listed before starting.
•Assemble the shed on a flat level surface.
•We recommend that 2 people assemble this shed.
•Assemble it where you intend to place it.
Arches and Purlins Installation

Fit rear cover, part I2 and door, part 14 using the
plastic marbles. Connect and fit parts 6 base tube
to each leg, part 3. Secure with pegs F, see Figure
B.

TOP TIP: Place the four bottom corners of the front and rear doors under the base
tube to prevent it from moving:
Then secure the frame and cover
by inserting the pegs to the holes
on the base tubes, parts 6

Step 5 Assembling the roof fastener
1. Press ‘D’to open out the handle ‘B’, then insert the end of the roof rope
through the central hole in the middle of the fastener, see ‘A’below, and
adjust ‘B’by moving back and forth.
Note: Do not pull the rope out of the cover completely
2. Before completely tightening, insert the hook in the hole at the end of the
base tubes (6), and continue tightening the roof fastener until you have the
desired tension on the roof.
Note: To avoid splitting the cover and breaking the rope, do not overtighten the
rope. Ensure the load is split evenly over the rope and periodically check the cover
is even at both ends of the shed as you are tightening the rope.

To loosen the fastener, open the handle ‘B’fully, by pressing ‘D’, so that it is in a
straight line and press and hold position C, shown below; with the other hand, pull
the end of the rope.
C
C

GUARANTEE
IMPORTANT
Please do not return this product without first calling the Customer Service
number below:
0871 911 7031*
Thank you for purchasing this product, which has been made to demanding high
quality standards and is guaranteed for domestic use against manufacturing faults
for a period of 12 months from the date of purchase.
Register your product for an extended 2-year warranty by visiting our website
www.gardengearonline.co.uk. The product must be registered, along with your
contact information, within 30 days of purchase. For full terms and conditions please
visit our website.
This guarantee does not affect your statutory rights. If your product fails due to a
defect in material or workmanship during this period, please return it to the place of
purchase. Normal wear and tear is not covered under the guarantee.
Any guarantee is invalid if the product has been misused or subject to neglect or an
attempted repair other than by our own service centre.
Due to continuous product improvement, we reserve the right to change the
product specification without prior notice.
After Sales Customer Service:
Branded Garden Products Ltd, Premier House, Hortonwood 7, Telford, TF1 7GP
Telephone: [phone]*
E-mail [email protected]
Please retain for future reference.
Colours and contents may vary.
*Calls cost 13p per minute, plus your phone company’s access charge